KVM-8 I nstaller/User Guide
14
On-Screen Dis play Operations
15
System Control and Maintenance

The following commands are used for system control and maintenance. Enter the

command sequences to perform the actions described in the table below.

Key Sequence

Action

<CM>Kn<Enter > Sets the keyboard scan set where n is a scan s et number 1-3.
<CM>MR< Enter> If you hot-plug your mouse cable, you may experience a loss of
mouse signal. Use this command to restore the signal if you are
using a PC with a standard PS/2 mouse driver.
<CM>MW< Enter> If you hot-plug your mouse cable, you may experience a loss of
mouse signal. Use this command to restore the signal if you are using
a PC with a Microsoft IntelliMouse or other wheel mouse driver.
<CM>AV<Enter> Displays the current rmware version of your KV M Switch.
<CM>SG<Enter > Enables the scan Go command (by address only).
<CM>SH< Enter> Enables the scan Halt command.
<CM>M+< Enter> Enables mouse suspension of scanning.
<CM>M- <Enter> Dis ables mouse suspension of scanning.
<CM>H1<Enter> Changes the hot-key sequenc e to the default: (NumLock, -).
<CM>H2<Enter > Changes the hot- key sequence to the 1st alternate: (NumLock, *).
<CM>H3< Enter> Changes the hot- key sequence to the 2nd alternate: (CTRL, ~).
<CM>OSD0 <Enter> Disables the OSD Sequence.
<CM>OSD1<Enter> Changes the OSD sequence to the default: (CTRL, CTRL).
<CM>OSD2< Enter> Changes the OSD sequence to the 1st alternate: (Alt, Alt).
<CM>OSD3< Enter> Changes the OSD sequence to the 2nd alternate: (Shif t, Shift).
<CM>ZM<Enter> Use thi s command to resynchronize the mouse after a device or
computer hot-plug. Repeat, if nec essary, until synchronization is re-
established. Note: Using this command whil e the mouse is operating
correctly will cause the mouse to lose sync .