USING THE REMOTE CONTROL
LOADING BATTERIES
Use two size-AAA (R03) batteries.
1 Remove the battery cover at the back of the remote control.
2 Insert batteries in the compartment, making sure the ± and — polarities are correctly aligned.
3 Reinstall the battery cover.
4 Press the RESET button using a thin stick.
Battery cover
NOTE:
•The battery life is approximately one year in normal use.
•When you replace the batteries, always change both batteries, and make sure they are the same type.
•If the remote control does not operate properly after replacing the batteries, press the RESET button using a thin stick.
•If you will not be using the unit for a long time, remove the batteries from the remote control.
HOW TO USE THE REMOTE CONTROL
Point the remote control towards the unit’s signal receiver window and press the desired button. The unit generates a beep when it receives the signal.
•Make sure there is no curtain or other object between the remote control and the unit.
•The remote control can send signals from up to 7 metres away.
CAUTION:
•Do not allow the signal receiver window to receive strong direct sunlight, since it can adversely affect its operation. If the signal receiver window is exposed to direct sunlight, close a curtain to block the light.
•Using a fluorescent lamp with a quick starter in the same room may interfere with transmission of the signal.
•The unit can be affected by signals transmitted from the remote control of a television, VCR or other equipment used in the same room.
•Do not leave the remote control in direct sunlight or near a heater. Also, protect the unit and remote control from moisture and shock which can discolour or damage them.
AUXILIARY MODE
Use this mode when the remote control is not available.
TO TURN ON
Lift the open panel of the indoor unit and press the AUX button.
•The red OPERATION lamp ( 
) on the unit will light and the unit will start operating in the AUTO mode.
•The fan speed and temperature setting are set to AUTO.
TO TURN OFF
Press the AUX button again.
•The red OPERATION lamp ( 
) on the unit will turn off.
AUX
NOTE:
•If the AUX button is pressed during normal operation, the unit will turn off.
