Sharp CS-2194H, CS-1194H operation manual Rounding Selector, Constant / ADD Mode Selector, Division

“•”:

5/4

GT

ROUNDING SELECTOR:

Example: Set decimal selector to “2”.

4 ⎟ 9 = 0.444 ... , 5 ⎟ 9 = 0.555 ...

4	9	5	9
	0.45		0.56
5/4	0.44		0.56
	0.44		0.55

Note: The decimal point floats during successive calculation by the use of or .

If the decimal selector is set to “F” then the answer is always rounded down ().

CONSTANT / ADD MODE SELECTOR:

“K” : The following constant functions will be performed:

Multiplication: The calculator will automatically remember the first

		number entered (the multiplicand) and			instruction.
Division:		The calculator will automatically remember the second
“•”:	Neutral	number entered (the divisor) and		instruction.
“A”:	Use of the Add mode permits addition and subtraction of numbers
	without entry of the decimal point. When the Add mode is activated,
	the decimal point is automatically positioned according to the deci-
	mal selector setting.
	Use of	, , and	will automatically override the Add mode and

decimally correct answers will be printed at the preset decimal position.

GRAND TOTAL MODE SELECTOR:

“GT”: This selector will accumulate the following: (“ ✱ +” will be printed.)

1.Addition and subtraction totals obtained with .

2.Product and quotient totals obtained with or .

3.Answers obtained with or .

Neutral

PAPER FEED KEY

LAST DIGIT CORRECTION KEY

GRAND TOTAL KEY:

Prints and clears the “GT” memory contents.

– 4 –