INSTALL WINDOW PANEL
Installation in a sliding sash window
"A"
1 Connect the rain guards to the insect guard net.
Insert all three projections on each rain guard into the holes in the insect guard net.
Side “A” will now be uppermost, as indicated in the diagram.
2 Attach the guard combined above to the window panel.
Push the insect guard net firmly to ensure that its four projections fit into the holes in the window panel.
Side “A” will now be at the top, as indicated in the diagram, when it is installed in the window.
Insect guard net
Hole
Projection
Projection
Rain guard
Window panel
"A"
3 Cut the foam seal A (adhesive type) to the proper length and attach it to the window frame.
4 Install the window panel into the window frame.
If the inner height of the window is between 22" (559mm) and 24" (609mm) inclusive.
The window panel cannot be installed in windows less than 22" (559mm) high, as you will be unable to shut the exhaust cover.
(1) Remove the adjustment panel from the window panel, and cut the window pan-
el to the same height as the window. Window
panel
(2) Open the window sash and place the window panel on the window frame.
(3) Secure the window panel to the window frame with 2 screws.
Foam seal A (adhesive type)
Cut
22"~24"
