DK-A10

DK-A10BK

System connections

Make sure to unplug the AC power cord before any connections.

Antenna connection

Supplied FM antenna:

iPod connecting to TV

iPod photo and 5th Generation iPod with photo and video can be view by connecting to TV/monitor.

If the TV/monitor has a video input, connect it to the VIDEO OUT jack on the rear of the unit.

Connect the FM antenna wire to the FM 75 OHMS jack and position the FM antenna wire in the direction where the strongest signal can be received.

Supplied AM loop antenna:

Connect the AM loop antenna to the AM and GND terminals. Position the AM loop antenna for optimum reception. Place the AM loop antenna on a

Video cable (not supplied)

TV

shelf, etc., or attach it to a stand or a wall with screws (not supplied).

To video input Jack

Preparation for Use

10

Note:

Placing the antenna on the unit or near the AC power cord may cause noise pickup. Place the antenna away from the unit for better reception.

Installing the AM loop antenna:

< Assembling >

< Attaching to the wall >

 

Wall Screws (not supplied)

Outdoor FM antenna

Use an outdoor FM antenna if you require better reception. Consult your dealer.

Outdoor

FM antenna

75 ohms coaxial cable

Note:

When an outdoor FM antenna is used, disconnect the supplied FM antenna wire.

AC power connection

After checking all the connections have been made correctly, plug the AC power cord of this unit into the AC outlet. If you plug in the unit first, the unit will enter the demonstration mode.

AC outlet
(AC 120 V, 60 Hz)
To AC input

Note:

Unplug the AC power cord from the AC outlet if the unit will not be in use for a prolonged period of time.

Demonstration mode

The first time the unit is plugged in, the unit will enter the low power consumption mode.

To activate the demonstration mode: When the unit is in the power stand-by mode (low power consumption mode), press the E SOUND/DEMO button. The unit will enter the demonstration mode.

To return to the low power consumption mode:

When the unit is in the power stand-by mode, press the E SOUND/ DEMO button again. The iPod terminal door will automatically close if iPod unit is not inserted.

Note:

When the power is on, the E SOUND/DEMO button can be used to select the E SOUND mode.