Remote control

DK-A10

DK-A10BK

Battery installation

This product contains a CR Coin Lithium Battery which contains Perchlorate Material – special handling may apply, California residents, see www.dtsc.ca.gov/hazardouswaste/perchlorate/

1While pushing the locking tab toward the center of the remote control, slide out the battery holder.

Back of remote control

Locking tab

2Remove the old battery from the battery holder, insert the new battery and then slide the battery holder back into the remote control.

Battery holder

Positive (+)

 

side up

Polarity (+) symbol

Battery type

Locking tab

Precautions for battery use:

Remove the battery if the unit will not be used for long periods of time. This will prevent potential damage due to battery leakage.

Caution:

Do not use rechargeable battery (nickel-cadmium battery, etc.). Installing the battery incorrectly may cause the unit to malfunction.

Notes concerning use:

Replace the battery if the operating distance is reduced or if the operation becomes erratic. Purchase “CR 2025”, coin lithium battery.

Periodically clean the transmitter on the remote control and the sensor on the unit with a soft cloth.

Exposing the sensor on the unit to strong light may interfere with operation. Change the lighting or the direction of the unit if this occurs.

Keep the remote control away from moisture, heat, shock, and vibrations.

Test of the remote control

Check the remote control after checking all the connections (see page 10).

Point the remote control directly at the remote sensor on the unit.

The remote control can be used within the range shown below: Press the ON/STAND-BY button. Does the power turn on? Now, you can enjoy music.

Remote sensor

CLOCK

VOL

SLEEP ALARM

Preparation for Use

PLAY

MODE

CLEAR EQ

11