Listening to the radio (continued)
■Memorizing a station
You can store 10 AM and 10 FM stations in memory and recall them at the push of a button. (Preset tuning)
1Perform steps 1 - 4 in “Tuning” on page 10.
2 Press the
3Within 1 minute, press the or button to select the preset channel number.
Store the stations in memory, in order, starting with preset channel 1.
4Within 1 minute, press the
If the preset number indicators disappear before the station is memorized, repeat the operation from step 2.
5Repeat steps 1 - 4 to set other stations, or to change a preset station.
When a new station is stored in memory, the station previously memorized for that preset channel number will be erased.
Note:
The backup batteries function protects the memorized stations should there be a power failure or the AC power cord becomes disconnected. If the backup batteries are drain off, the memorized stations will be erased.
■To recall a memorized station
Press the or button for less than 0.5 seconds to select the desired station.
Alarm and sleep operation
■Alarm
The unit turns on and play desired source (iPod or TUNER) or Buzzer sound for 1 hour alarm cycle.
Before setting the alarm:
1Check that the clock is set to the correct time. (refer page 8) If it is not set, you cannot use the alarm function.
2For iPod playback: Insert iPod to the unit. (refer page 9)
3For TUNER: Set preset memory. (refer left)
Setting the alarms
In this example, the setting is for ALARM 1. The same method is used to set for ALARM 2.
1Press and hold the ALARM 1 button until the alarm time flashing.
2Press the TUNING/SET ( or ) button to adjust the hour and then press the ALARM 1 button.
Press the TUNING/SET ( or ) button once to advance the time by 1 hour. Hold it down to advance continuously. “AM” or “PM” indicator will interchange after each 12 hour cyclic.
3Press the TUNING/SET ( or ) button to adjust the minutes and then press the ALARM 1 button.
MON
Press the TUNING/SET ( or ) button once to advance the time by 1 minute. Hold it down to change the time in 5 minutes interval.
4Press the TUNING/SET ( or ) button to select the wake up source and then press the ALARM 1 button.
Wake up source:
BUZZER RADIO iPod
Two beeps will indicate alarm setting is complete.
Note:
If wake up source is set to iPod, and iPod is not present, the alarm source will change to default Buzzer.
Caution:
During alarm activation, sound will be not output to the speaker if headphones is plugged in. Make sure to unplug the headphones if it is not used.
Volume auto
●If turn off the main unit with the volume set to lower than Vol 16, the wake up alarm volume will start at last set level and fades into the Vol 16.
●If turn off the main unit with the volume set to higher than Vol 16, the wake up alarm volume will starts at Vol 16 and fades into the last set level.
11