Sharp DKCL6N Specifications, Maintenance, Troubleshooting chart continued, Condensation, General

Troubleshooting chart (continued)

■Condensation

Sudden temperature changes, storage or operation in an extremely humid environment may cause condensation inside the cabinet or on the transmitter on the remote control.

Condensation can cause the unit to malfunction. If this happens, leave the power on until normal playback is possible (about 1 hour). Wipe off any condensation on the transmitter with a soft cloth before operating the unit.

■If problem occurs

When this product is subjected to strong external interference (mechanical shock, excessive static electricity, abnormal supply voltage due to lightning, etc.) or if it is operated incorrectly, it may malfunction.

If such a problem occurs, do the following:

1Set the unit to the stand-by mode and turn the power on again.

2 If the unit is not restored in the previous operation, unplug and plug in the unit, and then turn the power on.

Note:

If neither operation above restores the unit, remove the backup batteries.

■Clearing all the memory (reset)

Remove the backup battery from the main unit without connecting the AC/DC adaptor.

Caution:

This operation will erase all data stored in memory including clock, alarm settings and tuner preset.

■Before transporting the unit

Remove the iPod from the unit. Then, set the unit to the power standby mode. Carrying the unit with iPod left docked might damage both the unit and the iPod.

Specifications

As part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. The performance specification figures indicated are nominal values of production units. There may be some deviations from these values in individual units.

■ General

Power source	DC IN 12V	1A: AC/DC adaptor
	(AC 100 - 240 V ~ 50/60 Hz)
	Clock Backup: 3V		(UM-3/SUM-3, R6/
	AA) x 2
Power	P W
consumption
Output power	Front speakers:
	2 watts minimum RMS per channel into
	8 ohms from 100 Hz to 20 KHz, 10% total
	harmonic distortion.
Speaker	1-way type speaker system
	2.5" (6.5 cm) Full Range
Speaker maximum	4 W/Channel
input power
Speaker rated	2 W/Channel
input power
Output terminals	Headphones: 16 - 50 ohms
	(recommended: 32 ohms)
	Video output: 1Vp-p
Input terminals	Auxiliary (audio signal):
	500 mV/47 k ohms
Dimensions	Width: 9-31/64" (241 mm)
	Height: 2-61/64" (75 mm)
	Depth: 5-29/32" (150 mm)
Weight	P lbs. (P kg)

Maintenance

■Cleaning the unit

Periodically wipe the unit with a clean soft cloth.

Caution:

●Do not use chemicals for cleaning (gasoline, paint thinner, etc.). It may damage the unit finishing.

●Do not apply oil to the inside of the unit. It may cause malfunctions.

■Tuner

Frequency range FM: 87.5 - 108.0 MHz AM: 530 - 1,720 kHz

14