Sharp DV-RW550U Timer recording (cont’d), STOP, T-SET, T-SET, POWER, SETUP, Other Situations, Notes on Timer Recording, Timer Recording is in Standby

Recording

Timer recording (cont’d)Notes on Timer Recording

	• If there is a power failure or the unit has been unplugged for more than 1
Both DVD and VCR	minute, the clock setting and all timer settings will be lost.
	• If a programmed start and end time are the same, the recording will be set for
	24 hours automatically.
	• If a start time is earlier and an end time is later than the current time, the
	recording will start right after you press T-SET.
DVD	• If a disc becomes full during timer recording, the unit turns itself off. In such
	case, press T-SET. Insert a new disc. And then press T-SETagain to resume the
	timer recording.
VCR	• If a tape reaches the end during timer recording, the unit automatically ejects
	the tape. In such case, insert a new tape to resume the timer recording.

Limited Functions during Timer Recording

			Timer Recording is in Standby
Cancelling the Timer			• Press T-SET.
stanby mode.
Both DVD and VCR			• You cannot use any functions for either component (even after a timer record-
			ing on one component has already began).
Either DVD or VCR			• You cannot change output mode or use SETUP while the other component is
			in timer standby.
		OR	• You can turn on the side of the unit that is not in timer standby by pressing
			POWER, however you cannot use SETUP or change output mode.You only
			can play or make a basic recording while the other component is in timer
			standby.
			Timer Recording is in progress
Cancelling the Timer			• Press STOP C on the front panel of the Timer Recording side (VCR or DVD).
Recording.
Both DVD and VCR			• The timer recording cannot be performed in DVD and VCR at the same time. If
			you make two programmings withe the same channel and time in both compo-
			nents, the program with a lower program number will be recorded.
Either DVD or VCR			• You cannot change channels.
	OR

Other Situations

•If a basic recording or an OTR is in progress on one component (e.g.VCR) and the timer recording set for the other component (e.g. DVD) is about to begin, the unit automatically switches to the programmed channel 2 minutes before the programmed starting time, and the recording in progress (for VCR) will be cancelled UNLESS their recording channels are the same. If their recording channels are the same, the timer recording (for DVD) will start without cancelling the recording currently in progress (on the VCR). In this case, a recording of the same channel will be made on both DVD and VCR.

38