INSTALLATION INSTRUCTIONS
-Utilization of the package will make installation easier.
1.(For U.K., Australian, and New Zealand use)
A
(For Continental use)
The electric outlet must be installed at 150 mm high from the floor of the
2.Remove the
3.Place the oven on the package of the
Caution: | Make sure that the oven always keeps its balance to avoid falling over. |
4.Attach the aluminium sheet C onto the back panel D of the built in cabinet as shown in Fig. 1 and Fig. 2. Set the spacing brackets 1on the shelf along the right and left walls of the kitchen cabinet, keeping a distance of 17 mm between the front end of the shelf and the spacing brackets, and attach them
with the four screws 0, as shown in Fig. 1.
Caution: | The arrow marks on each spacing bracket should be pointing towards you. |
5.Insert two tabs of the intake duct 3 into the slits of the back plate E.
And install the intake duct 3 to the back plate E with one screw A as shown in Fig. 4.
6.Loosen screw F holding the outer wrap to the rear of the oven as shown in Fig. 4.
7.Install the exhaust duct 2 to the rear of the oven by tightening two screws A and F (loosend at step 6) as shown in Fig. 4.
8.Loosen screw G holding the back plate E to the rear of the oven as shown in Fig. 4.
9.Remove screw H from the oven as shown in Fig. 4.
10.Let the power supply cord pass through the hole of the lower side of the intake duct 4as shown in Fig. 5.
11.Install the intake duct 4to the rear of the oven with two screws G (loosened at step 8) and H (removed at step 9) as shown in Fig. 5.
Caution: | Avoid pinching the power supply cord between the oven and the intake duct 4 . |
12.Remove the backing paper from the three cushions 5, 6and 7. Attach the cushion 6at the top and left side of the intake duct 4and attach the cushion 7at the left side of the cushion 6and the oven as shown in Figs
13.(For U.K., Australian, and New Zealand use)
Place the oven on the spacing brackets on the shelf of the kitchen cabinet feeding the power supply cord through the prepared
(For Continental use)
Place the oven on the spacing brackets on the shelf of the kitchen cabinet.
14.Connect the oven to the power supply.
Caution: a. In U.K., Australia, and New Zealand, connect the oven to the power supply
15.Adjust the position of the oven so that the feet fit into the recesses of the spacing brackets as shown in
Fig. 2. |
|
Caution: | Make sure that the power supply cord does not touch the air vent openings behind the oven. |
16.Place the
17.Insert two
Note: Fit the hole of the
18.Install the second
Caution: | Make sure that the 7.5 mm of the frames (upper and lower) and cabinet overlap each other |
| as shown in Fig. 9, or the kitchen cabinet door may touch the |
2