CARE AND MAINTENANCE

WASHABLE ACTIVE CARBON FILTER CARE

HAND WASH ONLY!DO NOT TUMBLE DRY!

Care Cycle

When the CLEAN FILTER Indicator Light illuminates, this indicates that the filter needs to be cleaned. If the unit is kept on 24 hours a day then the CLEAN Filter Indicator Light will be activated in about 2 months.

The CLEAN FILTER Indicator Light is for reference. Clean the filter as often as necessary when odor persists.

1 Remove visible dirt with a vacuum cleaner.

2 Fill a large container up with warm water, add a mild kitchen detergent and stir.

Dilute as indicated on the detergent container.3 Allow the filter to soak approximately 30 minutes before washing.If the filter surface is very dirty, scrub with an old tooth- brush.CAUTION

Handle with care to prevent damage to the activated carbon particles.

4 Rinsewater thoroughly with clean

CAUTION

If rinsing in a con- tainer, be sure to rinse 3 to 4 times so that the odor is rinsed thoroughly from the filter.

5 Remove excess water

The filter will be saturated with water after rinsing. To decrease drying time, wrap the filter in an old thick towel so that excess water can be removed.

CAUTION

•Some carbon may ad- here to the towel, but it is harmless.

•Do not wring out the filter.

6 Dry the filter outdoors if possible in a well ventilated area.

CAUTION

•The wet filter is heavy. Fix it securely for drying to make sure it does not fall down.

•The filter takes longer to dry in winter, and on rainy days. Wash it on a day when the weather is good and dry it in the sun.

Move it indoors at night to prevent freezing.

•Dry the filter outdoors in a well ventilated area. If dried indoors, the water dripping off the filter may soil your floor.

•Make sure that the activated carbon has not shifted to one side inside the filter. If it has, distribute it evenly with your fingers.

•Let the filter dry thoroughly.

If used while the filter is still moist, then the air that is exhausted from the main unit will have an odor. It may take 1 or 2 days to dry.

7 Reinstalling the Filter.Reinstall the filter as shown on Page E-10,11

8 Once the Active Carbon Filter has been cleaned, connect the power cord to the outlet and press the Filter Reset Button on either the Remote Control or Main Unit.

•Once the Filter Reset Button has been acti- vated, you will hear a beep sound that means the unit has been reset.

•The Filter indicator light will then go out automatically.Filter Reset Button

E-16