CAUTIONS CONCERNING OPERATION

Do not block the intake and air outlet.

Do not use the unit near or on hot objects, such as stoves or heaters or where it may come into contact with steam.

Do not lay the unit down when using.

Always hold the handle on the back of the main unit when moving it.

Holding the front panel when carrying may cause it to detach, thus dropping the unit and resulting in bodily injury.

Do not operate the unit without the filter.Do not wash and reuse HEPA filter.

Not only does it not improve filter performance, it may cause electric shock or malfunction.

Clean the exterior with a soft cloth only. The unit surface may be damaged or cracked.

In addition, the sensor may malfunction as a result.

REMOTE CONTROL LIMITATIONS

DO NOT USE THE REMOTE CONTROL IN THE FOLLOWING LOCATIONS:

Any location where there is inverter lighting equipment or electronic spontaneous lighting equipment

The remote control may become inoperative. In this case, move away from such lighting equipment or change direction.

Location exposed to direct sunlight or fluorescent. The unit may not receive signals from the remote control.

INSTALLATION GUIDELINES

During the operation of the product, please place the unit at least 7feet(2m) away from equipment which involve electric wave such as televisions, radios or wave clocks, in case electrical interference occurs to such equipment.

Avoid a location where the sensor is exposed to direct wind. The unit may not operate properly.

Avoid locations where curtains, etc., come into contact with the intake or air outlet. Curtains, etc., may become dirty or a malfunction may occur.

Avoid locations where the unit is exposed to condensation, due to drastic temperature changes. (Use under appropriate conditions between 0 and 35˚C in the room.)

Place on a stable surface with sufficient air circulation.

When placing the unit on a heavily carpeted area, it may cause the unit to vibrate slightly.

Do not install when there is generation of lampblack, such as in a kitchen, etc. The unit surface may crack or the sensor may malfunction as a result.

Leave about 2feet(60cm) of space from the wall.

The wall behind the air outlet may become dirty as time passes. When using the unit for extended period of time in the same location, use a vinyl sheet, etc., to prevent the wall from becoming dirty. In addition, periodically clean the wall.

FILTER GUIDELINES

• Follow the instructions in this manual for correct care and maintenance of the filters.

ENGLISH FRANÇAIS ESPAÑOL

E-7