Appendix
Troubleshooting
The problems described below are not always caused by malfunctions. Check the TV again before having the TV serviced.
| Problem |
| Possible Solution |
|
|
|
|
• | No power. | • | Check if you pressed POWER on the remote control unit. (See page 13.) |
|
|
| If the indicator on the TV lights up red, press POWER. |
|
| • | Is the AC cord disconnected? (See page 9.) |
|
| • | Has the power been turned on? (See page 13.) |
|
|
|
|
• | Unit cannot be operated. | • | External infl uences such as lightning, static electricity, etc., may cause improper |
|
|
| operation. In this case, operate the unit after fi rst turning the power off the TV or |
|
|
| unplugging the AC cord and |
|
|
|
|
• | Remote control unit does not | • | Are batteries inserted with polarity (e, f) aligned? (See page 12.) |
| operate. | • | Are batteries worn out? (Replace with new batteries.) |
|
| • Are you using it under strong or fl uorescent lighting? | |
|
| • Is a fl uorescent light shining on the remote control sensor? | |
|
|
|
|
• | Picture is cut off. | • | Is the image position correct? (See page 32.) |
|
| • | Are screen mode adjustments such as picture size made correctly? (See pages 27, |
|
|
| 28 and 38.) |
|
|
|
|
• | Strange colour, light colour, or | • | Adjust the picture tone. (See pages 30 to 32.) |
| dark, or colour misalignment. | • | Is the room too bright? The picture may look dark in a room that is too bright. |
|
| • | Check the colour system setting. (See pages 19 and 36.) |
|
| • | Check the input signal setting. (See page 40.) |
|
| • | Check the HDMI Auto View setting. (See page 34.) |
|
|
|
|
• | Power is suddenly turned off. | • | The unit's internal temperature has increased. |
|
|
| Remove any objects blocking the vent or clean. |
|
| • | Check the power control setting. (See pages 25 and 26.) |
|
| • | Is the sleep timer set? (See page 25.) |
|
|
|
|
• | No picture. | • | Is the connection to external equipment correct? (See pages 10, 11, 34, 37 and 38.) |
|
| • | Has the input signal setup been performed correctly after connection? (See page |
|
|
| 40.) |
|
| • | Is the correct input selected? (See page 35.) |
|
| • | Is the picture adjustment correct? (See pages 30 to 32.) |
|
| • | Is the antenna connected properly? (See page 9.) |
|
| • | Is “On” selected in “Audio Only”? (See page 22.) |
|
|
|
|
• | No sound. | • | Is the volume too low? (See page 17.) |
|
| • | Make sure that headphones are not connected. (See page 7.) |
|
|
|
|
• | The TV sometimes makes a | • | This is not a malfunction. This happens when the cabinet slightly expands and |
| cracking sound. |
| contracts according to changes in temperature. This does not affect the TV's |
|
|
| performance. |
|
|
|
|
Cautions regarding use in high and low temperature environments
•When the unit is used in a low temperature space (e.g. room, offi ce), the picture may leave trails or appear slightly delayed. This is not a malfunction, and the unit will recover when the temperature returns to normal.
•Do not leave the unit in a hot or cold location. Also, do not leave the unit in a location exposed to direct sunlight or near a
heater, as this may cause the cabinet to deform and the LCD panel to malfunction. Storage temperature: f20°C to e60°C.
46
