Sharp LC-32SB24U operation manual On-ScreenDisplay Menu

On-ScreenDisplay Menu

Power control setting allows you to save energy.

Example I _ P_erOontrol

1 Press MENU to display the MENU screen, and then press _/1_ to select "Power Control".

2Press A/_" to select a "No Signal Off" or "No Operation Off", and then press ENTER.

3Press _/_- to select "Enable", and then press

ENTER.

4Press MENU to exit.

When set to"Enable", the power will automatically shut down if there is no signal for 15 minutes.

) Five minutes before the power shuts down, the remaining time displays every minute

•"Disable" is the factory preset va]ue.

When a TV program finishes, this function may not operate

When set to "Enable", the power will automatically shut down if there is no operation for 3 hours.

•Five minutes before the power shuts down, the remaining time displays every minute

"Disable" is the factory preset va]ue

Example

[ _ Setup

1 Press MENU to display the MENU screen, and then press _/_- to select "Setup".

2 Press A/_' toselect aspeciflc adjustment item, and then press ENTER.

When you select "EZ Setup", "OH Setup", "Parental CTRL" and "Reset", you can enter the 4-digit secret number here See page 22 for setting a secret number.

3Press _k/_' (or 4/1_) to select the desired setting, and then press ENTER.

4Press MENU to exit.

You can run EZ Setup again, even after setting up the preset channels.

Language: Select from among 3 languages (English, French and Spanish).

33/Location: Select "Home" or "Store" for the location where you plan to install the %/.

Ifyou select "Home", AV MODEis set to "STANDARD" Ifyou select "Store", AVMODE is setto "DYNAMIC(Fixed)" Inease no remote control signal is receivedwithin 30 minutes, AVMODE will changeto "DYNAMIC(Fixed)" automatically

Air/Cable: Make sure what kind of connection is made with your TV when selecting "Air" or "Cable"

CH Search: Channel auto search makes the TV look for a]l channels viewable in the set area.

See "Initial Setup" on page 12 for setting each item.

) If no channel isfound, confirm the type of connection made with your TV and try E7 Setup again

) Ifyou select "Analog Search Start" and initiate the channel search, the OH Memory for Cable Digital will be deleted.

If initial setup does not memorize all the channels in your region, follow the instructions below to manually memorize the channels.

Air/Cable: Make sure what kind of connection is made

with your %/when selecting "Air" or "Cable"

CH Search: Channel auto search makes the %/look for a]l channels viewable in the set area.

CH Memory: You can select the channels to skip in each ANALOG (Air),ANALOG (Cable), DIGITAL (Air) and DIGITAL (Cable)

On: Skips channels (Channel selectiondisabledusing DR A/V)

Off: Doesnot skipchannels (Channelselection enabledusing CHA/V)

See "Initial Setup" on page 12 for setting each iteln.

If no channel isfound, confirm the type of connection made with your %/and try channel search again.

Ifyou select "Analog Search Start" and initiate the channel search, the OH Memory for Cable Digital will be deleted.

In order to receive digital air broadcasts, you need a digital broadcast antenna. You can confirm the

antenna configuration through the "Antenna Setup DiGiTAL" screen. If necessary, adjust the direction of the antenna to obtain the maximum signal strength.

Signal Strength: The signal strength of DIGITAL channel is displayed The signal ]nformation is based on the current channel.

Channel Strength: Input the 2 digit channel number to check the signal strength of the selected channel Make sure the signa] is strong enough for each channel

Thisfunction isavailablefor DIGITAL(Air)only

2O