Sharp LC-32SB24U operation manual Appendix, Problem

Appendix

Problem	Possible Solution
• NO power	Check if you pressed POWER on the remote control	unit. (See page 12)	If the
	indicator on the %/does not light up, press POWER on the %/
	is the AC cord disconnected? (See page 7,)
	• Has the power been turned on? (See page 12)
• Unit cannot be operated	• External influences such as lightning, static electricity,	may cause improper	ope/ation.
	in this case, operate the unit affer first turning oft the power of the %/or unplugging
	the AC cord and replugging it in after 1 or 2 minutes

Remote control unit does not operate

Are batteries inserted with polarity ( J, ) aligned? (See page 8) Are batteries worn out? (Replace with new batteries.)

Are you using it under stlong or fluorescent lighting?

is a fluorescent light ilk_minated near the remote control sensor?

•Picture is cut off/with sidebar screen

Stlange color, light color, or color misalignment

Power is suddenly turned off

•NO picture

•Nosound

•Is the image position corlect? (See page 21 ,)

Are screen mode adjustments such as picture size made correctly? (See page 16.)

Adjust the picture tone. (See pages 18 and 19)

•Is the room too bright? The picture may look da/k in a room that is too bright. Check the input signal setting (See page 21 )

Is the sleep timer set? (See page 13)

•Check the power contlol settings. (See page 20)

The unit's internal temperature has incleased Remove any objects blocking vent or clean,

•Is connection to other components cor/ect? (See page 11 )

Is correct input signal source selected after connection? (See page 25)

•Is the cor/ect input selected? (See page 25,)

Is pictule adjustment correct? (See pages 18 and 19)

•Is "On" selected in "Audio Only"? (See page 24.)

o Is a nomcompatible signal being input? (See page 30,)

•Is the volume too low? (See page 13)

Is "Variable" selected in "Output Select"? (See page 25)

Have you pressed MUTE on the remote contlol unit? (See page 13)

• The %/sometimes		makes a	• This is not a malfunction. This happens					when	the cabinet slightly expands and
clacking sound			contracts	according	to change in temperature				This does not		affect the %/'s
			performance
The error message about reception of broadcast
The example of	an error message		Error code					Possible		Solution
displayed	on a screen
Failed to receive		broadcast,	E202	•	Check	the	antenna	cable	Check that the		antenna is correctly
					setup.
No b/oadcast	now,		E208	•	Check	the	broadcast time in the			program	guide,

Cautions regarding use in high and Jow temperature environments

•When the unR is used in a low temperatu/e space (eg. room, office), the picture may leave trails or appear slightly delayed This is not a malfunction, and the unit will recover when the temperature returns to normal

•Do not leave the unit in a hot or cold location, Also, do not leave the unit in a location exposed to direct sunlight or near a heater, as this may cause the cabinet to defofrrl and the Liquid Crystal panel to malfunction,

Storage temperature: 4°Fto 140°F( 2O°Oto I 6O°C)

28