16

Child Lock

Allow you to use a PIN to protect certain settings from
being accidentally changed.

Changing the PIN

1Press MENU and the MENU screen displays.
2Press c/d to select “Setup”.
3Press a/b to select “Child Lock”, and then press
OK.
New PIN –––
Reconfirm ––––
–
Change PIN
Reset
4Enter the 4-digit number as a PIN using 0 – 9.
5Enter the same 4-digit number as in step 4 to
confirm.
• “The system PIN has been changed successfully”
displays.
NOTE
• To view a locked channel (Lock setting in Programme
Setup “Manual Adjust” is set to “On”), you must enter a
PIN. (See page 15.) When you select a locked channel, a
PIN prompt message pops up. Press OK to display the
PIN input window.

Resetting the PIN

Allow you to reset your PIN to the factory preset “1234”.
1Repeat steps 1 to 3 in Changing the PIN.
2Enter the PIN.
3Press a/b to select “Reset”, and then press OK.
4Press c/d to select “Yes”, and then press OK.
NOTE
•As a precautionary measure, make a note of your PIN
on the back of this operation manual, cut it out and
keep it in a safe place that children cannot reach.
•See page 21 for resetting the current PIN to the factory
preset “1234” if you lose or forget your PIN.
Menu operations

Input Label

You can assign each input source a label you like.
1Press b to select the desired input source.
2Press MENU and the MENU screen displays.
3Press c/d to select “Setup”.
4Press a/b to select “Input Label”, and then press
OK.
5Press a/b/c/d to select each character of the
new name for the input source, and then press
OK.
6Repeat step 5 above until the name is fully spelt
out, and then press OK.
• The name can be 6 characters or less.
• If a label name is less than 6 characters, select
“END”, then press OK.
NOTE
• You cannot change the label if the input source is TV.
TV only

Fine Sync.

Menu Operation: C (Page 11)
Ordinarily, the TV automatically adjusts image positions
coming from PC (Auto Sync. function). In some cases,
however, manual adjustment is needed to optimise the
image.
H-Pos.: Centres the image by moving it to the left or right.
V-Pos.: Centres the image by moving it up or down.
Clock: Adjusts when the image flickers with vertical
stripes.
Phase: Adjusts when characters have low contrast or
when the image flickers.
PC only
NOTE
• If you need to adjust the image position, adjust the position
using your PC.
Item
LC-42SA1E_GB_b 06.9.8, 6:08 AM16