Direct Button Operation
HCI menu
In order to receive coded digital stations, a common interface module (CI module) and a CA card must be inserted in the CI slot of the TV.
Checking CI module information
HDemo (store mode only)
When “Store mode” is set to “On”, after all the settings are completed, the Feature demo screen is displayed if there is no operation for 30 seconds.
If you want to have fi ne motion demo, you must select “Fine motion” in Demo screen.
HSystem data
USB data transfer
This function allows you to update the TV to the latest software using a USB device. You must update the software through the USB terminal.
Software update (OAD)
• This function is for automatically download the |
data for the version update software over digital |
broadcasts when the “OAD setup” is set to “On”. |
ATV/DTV/RADIO buttons
Use the following buttons on the remote control to operate the menu.
ATV/DTV
HDMI
EPG GUIDE INFO RADIO
Programme Guide
•This menu is only available for digital stations.
•The content of this menu depends on the provider of the CI module.
Module
• General information on CI module displays.
Menu
• Adjustment parameters of each CA card displays.
Enquiry
•You can input numerical values such as passwords here.
NOTE
•Carefully insert the CI module in the CI slot with the contact side forward.
•The logo on the CI module must be facing outward from the rear of the TV.
•It takes a few minutes to certify the licence key when you insert a CA card into the CI+ compatible CI module for the
first time. This process may fail when there is no antenna input or you have never run “Auto installation”.
•The CI+ compatible CI module sometimes upgrades its
firmware. You may not receive any TV images before upgrading. You can only use the POWER during upgrading.
•Copy protected content may not be output or may be output with a copy control signal. The protect icon* is displayed when INFO is pressed while watching copy protected contents.
* Protect icon: X
•If the TV displays an update confi rmation message for the CA card while receiving CI+ compatible broadcasts, follow the screen prompts.
•Make sure that the CI module is properly inserted.
•If the old CAM is used, authentication may fail. In such cases, contact the contracted service provider.
• To download, follow the instructions when the |
download message appears during a digital |
broadcast. |
• Once the software upgrade is done, the TV will |
automatically go to standby state with Red LED. |
OAD scan
•This function is for manually download the data for the version update software over digital broadcasts.
CAUTION
•Do not disconnect the AC cord when the software upgrade is in progress, as this may cause the upgrade to fail. If problem arises ask a qualified service personnel before the software upgrade period expires.
You can check the current channel list of DTV/ATV respectively.
1 Press GUIDE to display the programme channel list.
2 Press a/b to select your desired programme, and then press ENTER.
3 Press RETURN or GUIDE to exit.
Info
While watching DTV you can check the extended programme information on the screen using INFO on the remote control.
General INFO screen
•Station name
•Title
•Date
•Time for the current programme
•Video system
•Audio system
•Parental rating
NOTE
•If there is more information, pressing a/b allows you to go to the next page or return to the previous page.
•You can cancel this info by pressing INFO.
DISPLAY
ATV/DTV
EPG GUIDE INFO RADIO
ATV/DTV: Press to switch between ATV and DTV mode. After switching from ATV or DTV, radio or external input mode to ATV and DTV mode, the TV jumps to the most recently viewed ATV and DTV channel.
RADIO: Press to switch from DTV to radio mode. The TV will jumps to the most recently tuned radio channel.
When you watch the TV for the first time
When the TV powers on for the fi rst time after purchase, perform the auto installation.
- 10
