Sharp LC 20D30U AUTO CLOCK Setting, MANUAL CLOCK Setting

Setting the CLOCK

AUTO CLOCK Setting

There are two methods of setting the clock: AUTO CLOCK and MANUAL CLOCK. AUTO CLOCK uses EDS signals, which are provided by some TV stations, to automatically adjust the clock. MANUAL CLOCK sets the clock manually in areas where no channel carries EDS signals.

1Press MENU to display the Menu screen.

2Press \/ to select “SETUP”.

3Press '/" to select “CLOCK”, and press ENTER.

SETUP� ��OPTION

C H � S E T U P

M T S

C L O C K

I N P U T 3 � S E L E C T

V ﾐ C H I P � B L O C K

C L O S E D � C A P T I O N

C O L O R � S Y S T E M

H D M I � S E T U P

P C � S E T U P

L A N G U A G E

4Press '/" to select “SET”, and press ENTER.

S E T

T I M E D I S P L A Y	A U T O
	M A N U A L

•CLOCK:

The AUTO CLOCK setting may take from several minutes to an hour depending on the number of channels to receive and signal status.

•EDS CH < AUTO >:

If there are no channels with EDS signals or the antenna signal is weak, the AUTO CLOCK Setting may not operate. In such a case, the message “EDS CH IS NOT AVAILABLE.” appears, and the CLOCK setting screen (in step 4 in AUTO CLOCK Setting) is displayed. Refer to MANUAL CLOCK Setting to set the clock manually.

•EDS CH < Not AUTO >:

If the channel you have selected for “EDS CH” is wrong or the EDS signal carrier is weak, or when there is no broadcast, the AUTO CLOCK Setting may not operate. In such cases, the message “EDS CH (XXX) EDS DATA IS NOT AVAILABLE.” appears, and the CLOCK setting screen (in step 4 in AUTO CLOCK Setting) is displayed as in the case with EDS CH

< AUTO >. Follow step 4 and repeat the AUTO CLOCK Setting procedure.

•If broadcasting channels are not memorized, EDS signals cannot be received even when the “EDS CH” is set to “AUTO”. In this case, try EZ SETUP again. (See page 25.)

MANUAL CLOCK Setting

If there are no channels with EDS signals, set the clock manually using MANUAL CLOCK.

1Repeat steps 1 to 4 of AUTO CLOCK Setting.

2Press '/" to select “MANUAL”, and press ENTER.

S E T

T I M E D I S P L A Y	A U T O
	M A N U A L

5Press '/" to select “AUTO”, and press ENTER.

●If you do not know the channel that carries EDS signals in your area, set “EDS CH” to “AUTO” and press ENTER. If you know the channel of the EDS signal carrier in your area, press \/ to select the channel and press ENTER.

S E T

T I M E D I S P L A Y

E D S C H

A U T O

●When set to “AUTO CLOCK”, the current time is acquired automatically when the main power is turned OFF. (This function will not work when EDS CH is not set.)

■Backup

The clock function is maintained for about 5 minutes even when the AC cord has been shut off due to a power outage or when moving the LCD TV set. (Since about 30 minutes are required to charge the backup power supply, it may not be possible to maintain the clock function if the charging time is excessively short.)

If the clock setting has been reset, repeat the procedures on this page.

3Press '/" to select “DST”, and press \/ to select “ON” or “OFF”.

Press '/" to select “TIME”, and press \/ to set the time, and press ENTER.

12:00AM 11:59AM