Sharp LC 20D30U Viewing an Image from a PC, Displaying an Image from a PC

Connecting a PC

Viewing an Image from a PC

Use the INPUT5 (PC-IN) terminals to connect a PC.

A

•The PC input terminals are DDC1/2B-compatible.

•Refer to page 39 for a list of PC signals compatible with the System.

•Make sure to select the same signal values for the output signal of a PC and the input signal of the LCD TV set before connecting with the PC. (See pages 38 and 39.)

•Depending on the PC being used, images may not be shown without converting the output signals into external output. Please refer to your PC’s manuals regarding converting to external output.

To ANALOG RGB	To ANALOG
output terminal	RGB terminal

RGB cable (supplied)

		PC				ø 3.5 mm stereo minijack cable
						(commercially available)		To AUDIO
						To Audio output
						terminal		input terminal
							Connecting the RGB cable
										• Connect the RGB cable making sure
							Ferrite core			that it fits correctly into the terminal.
										Then, firmly secure the connectors
										by tightening the screws on both
										sides of the plug.
										• Do not remove ferrite cores attached
										to the RGB cable.
Signal names for 15-pin mini D-sub connecter
5	4	3	2	1		Pin No.	Signal name	Pin No.	Signal name	Pin No.	Signal name
						1	R	6	GND (Ground)	q	Not connected
10	9	8	7		6
						2	G	7	GND (Ground)	w	SDA
15	14	13	12	11
						3	B	8	GND (Ground)	e	HD
						4	Not connected	9	+5V	r	VD
						5	CSYNC	0	GND (Ground)	t	SCL

A

•Pin No. 5 is not used for inputting the signal.

•Pin No. 9 is not connected with the supplied RGB cable.

Displaying an Image from a PC

To view an image from a PC, perform the following procedure.

1 Select the INPUT5 (PC) mode using INPUT on the remote control or the LCD TV set. (See page 18.)

2 Select the PC input signal. (See page 38.)

3 Adjust the “FINE SYNC.” items if the PC image does not come in clearly. (See page 38.)

37