Sharp LC 20DV20U Viewing an image from a PC, Displaying an image from a PC

Connecting a PC (Personal computer)

Viewing an image from a PC

Use the INPUT5 (PC) terminals to connect a PC.

NOTE

•The PC input terminals are DDC1/2B-compatible.

•Refer to page 28 for a list of PC signals compatible with the System.

•Make sure to select the same signal values for the output signal of a PC and the input signal of the TV/DVD set before connecting with the PC. (See page 28.)

•Depending on the PC being used, images may not be shown without converting the output signals into external output. Please refer to your PC’s manuals regarding converting to external output.

Connecting the RGB cable

• Connect the RGB cable making sure that it fits correctly into the terminal.

Then, firmly secure the connectors by tightening the screws on both sides of the plug.

					To ANALOG RGB		To ANALOG
					output terminal		RGB terminal
						RGB cable
					(commercially available)
	PC					Audio cable
				To Audio output	(commercially available)			To AUDIO
				terminals				input terminals
Signal names for 15-pin mini D-sub connecter
					Pin No.		Signal name	Pin No.	Signal name	Pin No.	Signal name
5	4	3	2	1	1		R	6	GND (Ground)	11	Not connected
10	9	8	7	6
					2		G	7	GND (Ground)	12	SDA
15	14	13	12	11
					3		B	8	GND (Ground)	13	HD
					4	Not connected		9	+5V	14	VD
					5		CSYNC	0	GND (Ground)	15	SCL

NOTE

•Pin No. 5 is not used for inputting the signal.

•Pin No. 9 is not connected with the supplied RGB cable.

Displaying an image from a PC

To view an image from a PC, perform the following procedure.

1 Select the INPUT5 (PC) mode using INPUT on the remote control or the TV/DVD. (See page 19.)

2Select the PC input signal. (See page 28.)

3Adjust the “PICTURE.” items if the PC

image does not come in clearly. (See page 28.)

SOURCE SELECTION

0.TV

1.INPUT1

2.INPUT2

3.INPUT3

4.INPUT4

5.INPUT5

[0-5]:SELECT

27