CAUTIONS
Each instruction also covers the optional units used with this product.
Caution label on the unit
The label ( 
, 
) in the fusing area of the unit indicates the following:
: Caution, risk of danger 
: Caution, hot surface
Cautions on using
Follow the cautions below when using this unit.
Warning:
•The fusing area is hot. Exercise care in this area when removing misfed paper.
•Do not look directly at the light source. Doing so may damage your eyes.
Caution:
•Place the unit on a firm, level surface.
•Do not install the unit in a humid or dusty location.
•When the unit is not used for a long time, for example during prolonged holidays, turn the power switch off and remove the power cord from the outlet.
•When moving the unit, be sure to turn the power switch off and remove the power cord from the outlet.
•Do not switch the unit rapidly on and off. After turning the unit off, wait 10 to 15 seconds before turning it back on.
•Do not cover the unit with a dust cover, cloth or plastic film while the power is on. Doing so may prevent heat radiation, damaging the unit.
•Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.
•The
Important points when selecting an installation site
Do not install your unit in areas that are:
•damp, humid, or very dusty
•exposed to direct sunlight
•poorly ventilated
•subject to extreme temperature or humidity changes, e.g., near an air conditioner or heater.
Be sure to allow the required space |
| 20 cm | |
around the machine for servicing |
| ||
|
| ||
and proper ventilation. | 10 cm | 10 cm | |
Cautions on handling | |||
|
| ||
Be careful in handling the unit as |
|
| |
follows to maintain the performance of |
|
| |
this unit. |
|
|
Do not drop the unit, subject it to shock or strike it against any object. Store spare toner cartridges in a cool dry place without removing from the package before use.
• If they are exposed to direct sunlight or excessive heat, poor copies may result.
Do not touch the photoconductive drum (green portion).
• Scratches or smudges on the drum will cause dirty copies.
Proper storage
Store the supplies in a location that is:
•clean and dry,
•at a stable temperature,
•not exposed to direct sunlight
Store paper in the wrapper and lying flat.
•Paper stored out of the wrapper or in packages standing on end may curl or get damp, resulting in paper misfeeds.
CAUTION:
Do not install the machine in a location with poor air circulation.
A small amount of ozone is created inside the machine during printing. The amount of ozone created is not sufficient to be harmful; however, an unpleasant odor may be noticed during large copy runs, and thus the machine should be installed in a room with a ventilation fan or windows that provide sufficient air circulation. (The odor may occasionally cause headaches.)
*Install the machine so that people are not directly exposed to exhaust from the machine. If installed near a window, ensure that the machine is not exposed to direct sunlight.
Supply and Consumables
The supply of spare parts for a repair of the appliance is guaranteed for at least 7 years following the termination of production. Spare parts are those parts of the apparatus which may break down within the scope of ordinary use of the product, whereas those parts which normally exceed the life of the product are not considered spare parts. Consumables also, are available for 7 years following the termination of production.
MSDS (Material Safety Data Sheet)
The MSDS (Material Safety Data Sheet) can be viewed at the following URL address:
In some areas, the "POWER" switch positions are marked "I" and " " on the copier instead of "ON" and "OFF".
If your copier is so marked, please read "I" for "ON" and " " for "OFF".
Caution!
For a complete electrical disconnection, pull out the main plug.
The
Shielded interface cables must be used with this equipment to maintain compliance with EMC regulations.
Laser information
Wave length | 780 nm+15 nm | |
| ||
Pulse times | 12.88 µs ±12.88 ns/7 mm | |
Output power | Max 0.2 mW |
At the production line, the output power of the scanner unit is adjusted to 0.18 MILLIWATT PLUS 5% and is maintained constant by the operation of the Automatic Power Control (APC).
Caution
Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.
This Digital Equipment is CLASS 1 LASER PRODUCT (IEC
This product is designed for commercial application only and as such it falls outside the scope of Regulation (EC) 1275/2008 implementing EU Directive 2005/32/EC on
Products that have earned the ENERGY STAR® are designed to protect the environment through superior energy efficiency.
The products that meet the ENERGY STAR® guidelines carry the logo shown above.
The products without the logo may not meet the ENERGY STAR® guidelines.
SOFTWARE LICENSE
The SOFTWARE LICENSE will appear when you install the software from the
Trademark acknowledgements
•Microsoft®, Windows®, Windows® 2000, Windows® XP, Windows Vista® and Internet Explorer® are registered trademarks or trademarks of Microsoft Corporation in the U.S.A. and other countries.
•Adobe®, the Adobe® logo, Acrobat®, the Adobe® PDF logo, and ReaderTM are registered trademarks or trademarks of Adobe Systems Incorporated in the United States and other countries.
•IBM, PC/AT, and PowerPC are trademarks of International Business Machines Corporation.
•Sharpdesk is a trademark of Sharp Corporation.
•All other trademarks and copyrights are the property of their respective owners.
Do not make copies of anything which is prohibited from copying by law. The following items are normally prohibited from copying by national
law. Other items may be prohibited by local law. |
| ||
Money | Stamps | Bonds | Stocks |
Bank drafts | Checks | Passports | Driver's licences |
|
|
|
|
Emission density (measured according to RALUZ122: Edition June 2006)
Measured | Condition of | Colour mode | Diffusion speed | ||
chemicals | copier | ||||
Ozone |
|
| Black and white | 1.5 gm/h or less | |
Dust | When copier is in |
| Black and white | 4.0 gm/h or less | |
Styrene |
| Black and white | 1.0 gm/h or less | ||
operation |
| ||||
Benzene |
|
| Black and white | 0.05 gm/h or less | |
TVOC |
|
| Black and white | 10 gm/h or less | |
When on standby | - | 2.0 gm/h or less | |||
| |||||
4
