Sharp PG-C20XE Resetting the lamp timer, Remove the lamp cage cover, Insert the new lamp cage

Replacing the Projection Lamp

7 Remove the lamp cage cover. 8 Remove the lamp cage.

Turn over the projector and loosen the user service screw that secures the lamp cage cover. Then lift open the cover in the direction of the arrow.

Loosen the securing screws on the lamp cage. Hold the lamp cage by the handle and pull it towards you.

&Troubleshooting

Maintenance

9 Insert the new lamp cage.	10 Attach the lamp cage cover.
Press the lamp cage firmly into the lamp cage	Slide the lamp cage cover in the direction of the
compartment. Fasten the securing screws.	arrow. Then tighten the user service screw.

Resetting the lamp timer

1 cord.Connect the power	2 Reset the lamp timer.
Plug the power cord into the AC	1 Press KEYSTONE ∂ and				“LAMP 0000H” is
socket of the projector.	KEYSTONE ƒ on the projector at				displayed, indicating that
	the same time.				the lamp timer is reset.
	2 Press INPUT and AUTO SYNC on
	the projector at the same time.
	3 Press AUTO SYNC and MENU on
	the projector at the same time.
	1
		INPUT	AUTO SYNC
	2	BACK	ENTER MENU	3

•Reset the lamp timer only after replacing the lamp.

41