Sharp PN-R703, PN-R603 53 E, Connect the PC to the monitor, Send commands to control the monitor

Controlling the Monitor with a PC (LAN)

[Advanced operation] Command-based control

You can control the monitor using RS-232C commands (see page 36) via terminal software and other appropriate applications.

In order to use this function, enable a connection to the monitor through Internet Explorer.

Read the manual for the terminal software for detailed instructions.

(1)Connect the PC to the monitor.

1.Specify the IP address and data port number and connect the PC to the monitor.

When connection has been established successfully,

[ Login:] is returned as response.

2.Send the user name set in the SECURITY settings (see page 49).

•Send [User name] + [ ].

•If the user name is not set, send [ ].

•When the transmission is successful, [ Password:] is returned as response.

3.Send the password set in the SECURITY settings (see page 49).

•Send [Password] + [ ].

•If the password is not set, send [ ].

•When the transmission is successful, [OK ] is returned as response.

(2)Send commands to control the monitor.

•The commands used are the same as those for RS-

232C. Refer to the communication procedure (see page 33) for operation.

•Usable commands are provided in the RS-232Ccommand table (see page 37).

(3)Disconnect the connection with the monitor and quit the function.

1.Send [BYE ].

When the transmission is successful, [goodbye] is returned and the connection is disconnected.

TIPS

•Connection is automatically disconnected when the time specified in AUTO LOGOUT TIME elapses over a no‑communication period.

53 E