Sharp R-1754 R E P L A C I N G P A R T S, Charcoal Filter, Work Light And Night Light, Oven Light

R E P L A C I N G P A R T S

CHARCOAL FILTER

Charcoal Filter, Sharp Part number RK-230 which was enclosed with your oven, is used for nonvented, recirculated installation. The filter should be changed every 6 to 12 months depending on use. See page 6 for ordering information.

1.Disconnect power to the oven at the circuit breaker panel or by unplugging.

2.Remove center screw from the top center of the louver and push down carefully on the tab at each end of the louver to disengage.

3.Pull the louver away from the unit.

4.Change the charcoal filter.

5.To replace, insert the top tabs of hood louver into the 3 openings on the cavity faceplate holding louver at a slightly outward tilt. Rotate louver so the top tabs are positoned in the cavity faceplate openings. Push in the bottom of louver to ensure that the three bottom clips snap into the cavity faceplate. Check for proper engagement and replace the screw removed in step 2.

Top tabs

Oven light

Screw

3.Remove old light bulb and replace only with equivalent watt bulb available from a Sharp Authorized Servicer or parts distributor. Bulbs are also available at most hardware stores or lighting centers. DO NOT USE BULB LARGER THAN 30 WATTS.

4.Replace the oven light cover by carefully pushing into place. Replace the charcoal filter, if used. Push the louver back into place and replace the louver mounting screw.

WORK LIGHT AND

NIGHT LIGHT

1.To replace light bulbs, first disconnect power to the oven at the circuit breaker panel or by unplugging.

2.To release cover, remove the screw on the light cover. (See illustration.)

3.Replace light bulbs with equivalent watt bulb available from your Sharp Authorized Servicer or parts distributor. Bulbs are also available at most hardware stores or lighting centers. DO NOT USE A BULB LARGER THAN 30 WATTS.

4.Close light cover and secure with screw removed in step 2.

CAUTION: Light cover may become very hot. Do not touch glass when light is on.

Cavity faceplate

Hood louver

Charcoal

filter

Bottom clips

OVEN LIGHT
Remove the louver per instructions 1-3 above and
charcoal filter, if used.	Light cover		Light bulbs
1. To replace light bulb, first disconnect power to the
		Screw
oven at the circuit breaker panel or by unplugging.

2.Open light cover located behind filter mounting by carefully pulling up on the front edge.

36