Sharp R-222T(W), R-201T(W) operation manual Installation Instructions, Oven Diagram

INSTALLATION INSTRUCTIONS

1.Remove all packing materials from the oven cavity, (do not remove the waveguide cover), and the feature sticker from the outside of the door, if there is one. Check the unit for any damage, such as a misaligned door, damaged door seals around the door or dents inside the oven cavity or on the door. If there is any damage, please do not operate the oven until it has been checked by a SERVICE CENTRE APPROVED BY SHARP and repaired, if necessary.

2.Accessories provided

1) Turntable 2) Roller stay

3) Operation manual and Cooking guide

3.Place the roller stay in the coupling on the oven floor, then place the turntable on to the roller stay, ensuring it is located firmly. Refer to OVEN DIAGRAM below. NEVER operate the oven without the roller stay and turntable.

4.This oven is designed for countertop or cabinet use as well. It should not be installed in any area where excessive heat and steam are generated, for example, next to a conventional oven unit. The oven should be installed so as not to block ventilation openings. Allow a space of at least 10 cm on the top, 5 cm on both sides and at the rear of the oven for adequate air circulation. When installing in a cabinet, the minimum inside dimension of the cabinet should be 560 mm (W) x 375 mm (H) x 418 mm (D). This oven is not designed for built-in installation.

WARNING: The electrical outlet must be readily accessible so that the unit can be unplugged easily in an emergency.

5.Neither the manufacturer nor the distributors can accept any liability for damage to the machine or personal injury for failure to observe the correct electrical connecting procedure.

The A.C. voltage must be single phase 230 – 240V, 50Hz.

6.This appliance must be earthed.

7.Operate the oven from a general purpose domestic outlet.

If a generator is used, do not operate the oven with non-sinusoidal outputs.

OVEN DIAGRAM

1.	Door open button	8.	Waveguide cover (Do not remove)
2.	Oven lamp	9.	Touch control panel (See page 5)
3.	Door hinges	10.	Liquid crystal display
4.	Door safety latches	11.	Ventilation openings
5.	See through door	12.	Power supply cord
6.	Door seals and sealing surfaces	13.	Turntable
7.	Coupling	14.	Roller stay

4

R201T(W) [01-15].indd 4

6/18/10 5:25:10 PM