Sharp R-930AW service manual Door Disassembly, Figure C-5. Door Replacement and adjustment

R-930AK

R-930AW

Note: The door on a microwave oven is designed to act as an electronic seal preventing the leakage of microwave energy from oven cavity during cook cycle. This function does not require that door be airtight, moisture (condensation)-tight or light-tight. Therefore, occasional appearance of moisture, light or sensing of gentle warm air movement around oven door is not abnormal and do not of themselves indicate a leakage of microwave energy from oven cavity. If such were the case, your oven could not be equipped with a vent, the very purpose of which is to exhaust the vapor-laden air from the oven cavity.

UPPER OVEN HINGE

RE-INSTALL

DOOR ASSEMBLY

LATCH

HEADS

LOWER OVEN HINGE

RE-INSTALL

Figure C-5. Door Replacement and adjustment

DOOR DISASSEMBLY

Remove door assembly, refer to "Door Replacement". Replacement of door components are as follows:

1.Place door assembly on a soft cloth with latches facing up.

Note: As the engaging part of choke cover and door panel are provided at several places, do not force any particular part.

2.Insert an putty knife (thickness of about 0.5mm) into the gap between the choke cover and corner portion of door panel as shown Figure C-6 to free engaging parts.

3.Lift up choke cover.

4.Now choke cover is free from door panel.

2 LIFT UP

PUTTY KNIFE

1 BENT

CHOKE COVER

Door Bent

Panel

Upper

INSIDE Choke

cover

Lower

FRONT

Figure C-6. Door Disassembly

32