Sharp VL-AH150U Inserting and Removing, Inserting the Battery Pack, Removing the Battery Pack

Models: VL-AH160U VL-AH150U

1 80
Download 80 pages 60 Kb
Page 16
Image 16

Preparation

Preparationreparation

Inserting and Removing the

4 Close the door, pressing it firmly in the

Battery Pack

center until it clicks.

 

Inserting the Battery Pack

1 Make sure that the Power switch is set to OFF.

Power switch

2 Slide the battery compartment door release on the bottom of the VIEWCAM in the direction of the arrow to open the battery compartment door.

Battery compartment door release

3 Insert the battery pack into the com- partment as shown, and push it in com- pletely until it locks into place.

Caution:

Do not force the battery pack into the battery compartment if it does not go in easily.

Removing the Battery Pack

1 Perform steps 1 and 2 above.

2 Press the battery release as shown to remove the battery pack.

Battery release

Cautions:

BEFORE REMOVING THE BATTERY PACK, ALWAYS STOP THE TAPE AND TURN THE POWER OFF. If you remove the battery pack during recording or playback, the tape will remain wound around the video head drum, potentially causing damage to the tape.

Make sure the battery compartment door is closed firmly during operation. If it is not, the battery pack may fall out or VIEWCAM operation may fail because of the poor contact pressure.

Remove the battery pack from the VIEWCAM if the VIEWCAM will not be used for a long period of time.

When removing the battery pack, do not tilt the VIEWCAM so that the battery compart- ment faces down. The battery pack may fall out.

Do not expose the battery compartment door to strong force, as it may come off.

Use only SHARP model BT-H22 or BT-H32 battery packs with this VIEWCAM. Use of other batteries may present a risk of fire or explosion.

7

Page 16
Image 16
Sharp VL-AH150U, VL-AH160U Inserting and Removing, Inserting the Battery Pack, Removing the Battery Pack