Connecting to a Computer

Before connecting, ensure that the power cord of the projector is unplugged from the AC outlet and turn off the devices to be connected. After making all connections, turn on the projector and then the other devices. When connecting a computer, ensure that it is the last device to be turned on after all the connections are made.

Ensure that you have read the operation manuals of the devices to be connected before making connections.

Supplied

RGB Cable

accessory

 

 

To audio output terminal

 

 

Computer

 

 

To RGB output terminal

To INPUT1 terminal

To AUDIO

 

 

 

(INPUT1, 2)

 

 

terminal

*ø3.5 mm stereo or mono audio cable (commercially available or available as Sharp service part QCNWGA038WJPZ)

RGB Cable

*When using the ø3.5 mm mono audio cable, the volume level will be half of when using the ø3.5 mm stereo audio cable.

Connections

Note

See page 60 “Computer Compatibility Chart” for a list of computer signals compatible with the projec- tor. Use with computer signals other than those listed may cause some of the functions to not work.

A Macintosh adaptor may be required for use with some Macintosh computers. Contact your near- est Macintosh Dealer.

Depending on the computer you are using, an image may not be projected unless the computer’s external output port is switched on. (e.g. Press “Fn” and “F5” keys simultaneously when using a SHARP notebook computer). Refer to the specific instructions in your computer's operation manual to enable your computer’s external output port.

23