Controlling the Projector by a Computer
When the RS-232C terminal on the projector is connected to a computer with a DIN-D-sub RS- 232C adaptor and an RS-232C serial control cable (cross type, commercially available), the computer can be used to control the projector and check the status of the projector. Refer to the “SETUP MANUAL” contained on the supplied CD-ROM for details.
When connecting to a computer using an RS-232C serial control cable and a DIN- D-sub RS-232C adaptor
DIN-D-sub | To RS-232C terminal |
|
RS-232C | |
adaptor | |
Computer
To RS-232C terminal
DIN-D-sub RS-232C adaptor
RS-232C serial control cable (cross type, commercially available)
Note
•The RS-232C function may not operate if your computer terminal is not correctly set up. Refer to the operation manual of the computer for details.
•Refer to page 3 of the “SETUP MANUAL” contained on the supplied CD-ROM for “RS-232C Speci- fications and Commands”.
Info
•Do not connect the RS-232C cable to a port other than the RS-232C terminal on the computer. This may damage your computer or projector.
•Do not connect or disconnect an RS-232C serial control cable to or from the computer while it is on. This may damage your computer.
