E-11
Setup & Connections

Connecting the Power Cord

Plug the supplied power cord into the AC socket on the back of the projector.

Connecting the Projector to a Computer

You can connect your projector to a computer for projection of full color computer images.

Connecting a computer using the standard 15-pin Input

Power cord
QACCU5013CEZZ
1To use the Standard 15-pin connector, slide the 15 pin/
BNC switch on the rear terminals to the 15 pin position.
2Connect one end of the supplied computer RGB cable
to the COMPUTER-RGB INPUT 1 or 2 port on the
projector.
3Connect the other end to the Monitor output port on the
computer. Secure the connectors by tightening the
thumb screws.
4To use the built-in audio system, connect one end of
the supplied computer audio cable to the AUDIO INPUT
1 or 2 terminal on the projector.
5Connect the other end to the Audio output terminal on
the computer.
CAUTION
•Before connecting, be sure to turn both the projector and the
computer off. After making all connections, turn the projector
on first. The computer should always be turned on last.
•Please read the computer’s operation manual carefully.
•Refer to page 55 “Computer Compatibility Chart” for a list of computer
signals compatible with the projector. Use with computer signals other
than those listed may cause some of the functions not to work.
When connecting this projector to a computer, select
“Computer/RGB” for “Signal Type” on the GUI menu. (See
page 27.)
•A Macintosh adaptor may be required for use with some Macintosh
computers. Contact your nearest Authorized Sharp Industrial LCD
Products Dealer or Service Center.
Computer audio cable
QCNW-4870CEZZ
Computer RGB cable
QCNW-5304CEZZ
1 2
Connecting the Projector