
Controlling the Projector via LAN
After connecting the projector to your network, enter the projector IP address in “Address” on Internet Explorer (version 5.0 or later) using a computer on the network to start a setup screen that will enable control of the projector via the network.
Controlling the ProjectorUsing Internet Explorer(Version 5.0 or later)Complete connections to external equipment before starting the operation. (See pages 24- 27 of the projector’s operation manual.)
Complete the AC cord connection. (See page 28 of the projector’s operation manual.)
Note
•When connecting the projector to the LAN, use a commercially available LAN cable (UTP cable, Category 5,
1
2
Enter “http://” followed by the projector IP address set by the procedure on page 25 followed by “/” in “Address”, and then press the “Enter” key.
•The factory default setting for the projector : “DHCP Client” is “OFF” and IP address is “192.168.150.2”. If you did not change the IP address in “3. Setting up a Network Con- nection for the Projector” (pages 24, 25), enter “http://192.168.150.2/”.
3 A screen for controlling the projector appears, ready for performing various status condi- tions, control, and settings.
-26