Stack Projection

The stack projection allows you to increase the brightness of an image by stacking two projectors and projecting same image simultaneously.

Info

•To set up the stack projection, assign a projector as the master and the other projector as the slave and connect the projectors with commercially available LAN cables (UTP cable, Category 5, cross-over type). In this way, you can control the both projectors with one remote control.

•The buttons below can control both the master and the slave at one time.

• ON button

• VOLUME buttons

• STANDBY button

• AUTO SYNC button

• SHUTTER button

• RESIZE button

• COMPUTER1/2, DVI, HDMI,

• PICTURE MODE button

VIDEO, S-VIDEO buttons

• BREAK TIMER button

• MUTE button

• FREEZE button

•In normal operation, the projector set as the slave cannot be controlled by the remote control.

Only while the remote control is connected to the projector with a ø3.5 mm minijack cable (commercially available or available as Sharp service part QCNWGA038WJPZ), the projector set as the slave can be controlled by the remote control.

•Even while the projector is set as the slave, the buttons on the projector can be used.

-41