![](/images/new-backgrounds/1165895/165895209x1.webp)
Problem | Check | Page |
The projector cannot be | • If the “Keylock Level” menu is set to “Level A” or “Level B”, all or | 85 |
turned on or put into the | specific buttons on the projector are unavailable. Use the |
|
standby mode using the | remote control to operate the projector. |
|
ON or STANDBY button |
|
|
on the projector. |
|
|
All buttons on the | • If the “Stack Setting” menu is set to “Slave” and the “Keylock | 18 |
projector and the remote | Level” menu is set to “Level B”, all buttons on the projector and | 84 |
control are unavailable. | the remote control are unavailable. Connect the remote control | 85 |
| to the projector, and then use the remote control to operate the |
|
| projector. |
|
Picture is green on | • Change the input signal type setting. | 63 |
INPUT 1or 2 |
|
|
(COMPONENT). |
|
|
Picture is pink (no green) |
|
|
on INPUT 1, 2 or 3 |
|
|
(RGB). |
|
|
Picture is too bright and | • Image adjustments are incorrectly set. | 60 |
whitish. |
|
|
The cooling fan | • When temperature inside the projector increases, the cooling | 9, 10 |
becomes noisy. | fan runs faster. | 93 |
The lamp does not light | • The lamp indicator is illuminating in red. | 94 |
up even after the | Replace the lamp. |
|
projector turns on. |
|
|
The lamp suddenly turns |
|
|
off during projection. |
|
|
The image sometimes | • Cables incorrectly connected to the projector or the connected | |
flickers. | equipment works improperly. |
|
| • If this happens frequently, replace the lamp. | 97 |
The lamps take a long | • The lamps will eventually need to be changed. | 97 |
time to turn on. | The lamps have reached the end of its life. Replace the lamps. |
|
Picture is dark. |
|
|
The remote control | • Operate the remote control while pointing it at the projector’s | 17 |
cannot be used. | remote control sensor. |
|
| • The remote control may be too far away from the projector. |
|
| • If direct sunlight or a strong fluorescent light is shining on the |
|
| projector’s remote control sensor, place the projector where it |
|
| will not be affected by strong light. |
|
| • The batteries may be depleted or inserted incorrectly. Make | 17 |
| sure the batteries are inserted correctly or insert new ones. |
|
|
|
|
This projector is equipped with a microprocessor. Its performance could be adversely affected by incorrect operation or interference. If this should happen, unplug the projector and plug it in again after more than 5 minutes.
Appendix
-103
![](/images/new-backgrounds/1165895/165895209xi2.webp)