Sharp XL-HP505 Tape Recording, Recording on a cassette tape (continued)

26
XL-HP505
Tape Recording
Recording on a cassette tape (continued)
Recording from several CDs continuously:
To perform programmed recordi ng:
To stop recording:
Press the (TAPE ) button.
The CD and tape will stop.
Auto restart function:
If the r ecording side is switched from side A to B during recording,
the system will record the interrupted track on side B from its begin-
ning. The recording will be made without cutting the beginning of the
track on side B.
!Recording from the radio
To interrupt recording:
Press the button.
To resume recordi ng, press the same recording button you pressed
in step 5. Other buttons do not allow resu ming.
To stop recording:
Press the (TAPE ) button.
Note:
If you hear a whistling noise while recording an AM station, move
the AM loop antenna.
!Erasing recorded tapes
1 Press the TAPE button.
2 Follow steps 2 - 5 in "Recording from the radio".
1 Perform steps 1 - 6 in "Recording from a CD (CDs)" on page 25.
2 Within 5 seconds, press the / ( ) button to record on side A,
or the button for si de B.
1 Program discs and tracks. (See page 20.)
2 Press the button.
3 Press the / ( ) button to record on side A, or the button for
side B.
1Tune in to the desired station. (See page 21.)
2Load a cassette into the cassette compartment with side A
facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3Press the button to choose one side or both sides.
... To record on both sides.
... To record on only one
side.
4Press the button.
Recording will be paused.
5Press the / ( ) button to record on side A, or the but-
ton for side B.
To record on both sides, begin with side A. (If recording is start-
ed from side B, the tape will not switch over to side A.)