Remote control |
| General control |
■Battery installation
1Open the battery cover.
2Insert the batteries according to the direction indicated in the battery compartment.
When inserting or removing the batteries, push them towards the
3Close the cover.
Caution:
●Replace all old batteries with new ones at the same time.
●Do not mix old and new batteries.
●Remove the batteries if the unit will not be used for a long period of time. This will prevent potential damage due to battery leakage.
●Do not use rechargeable batteries
●Installing the batteries incorrectly may cause the unit to malfunction.
●Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like.
Notes concerning use:
●Replace the batteries if the operating distance is reduced or if the operation becomes erratic. Purchase 2 “AAA” size batteries
●Periodically clean the transmitter on the remote control and the sensor on the unit with a soft cloth.
●Exposing the sensor on the unit to strong light may interfere with operation. Change the lighting or the direction of the unit if this occurs.
●Keep the remote control away from moisture, heat, shock, and vibrations.
■Test of the remote control
Check the remote control after checking all the connections. Point the remote control directly at the remote sensor on the unit. The remote control can be used within the range shown below:
Remote sensor
0.2 m - 6 m (8" - 20' )
VOLUME
■To turn the power on
Press the
After use:
Press the
■Volume auto set-in
●If you turn off and on the main unit with volume set to 16 or higher, the volume will start at 16.
●If you turn the unit off then on again with the volume level set to less than 16, it will turn on again at the level set.
■Volume control
Turn the volume knob towards VOLUME +/– (on main unit) or press VOL +/– (on remote control) to increase or decrease the volume.
2012/ October/ 17 | |
|
