Sharp XL-UR14H operation manual Setting the clock Remote control only

General control (continued)

■Extra bass Control (X-BASS)

Press and hold down (X-BASS)/EQ button, the unit will enter the extra bass mode which emphasises the bass frequencies and “X-BASS” indicator will light up.

To cancel the extra bass mode, press and hold down (X-BASS)/EQ button again.

■Equalizer

Press (X-BASS)/EQ button, the current mode setting will be displayed. To change to a different mode, press the (X- BASS)/EQ button repeatedly until the desired sound mode appears.

FLAT	equalisation.
	Noo equalization.
ROCK	rock music.
	Foror rock music.
CLASSIC	music.
	Foror clasclassicalical music.
POPS	For pop music.
	or pop music.

VOCAL Vocalscals arearenhancedenhanced. .

JAZZ Forr jazzjazz. .

■Auto power off function

The main unit will enter the stand-by mode after 15 minutes of inactivity during:

CD / USB: In the stop or pause mode.

AUDIO IN: No detection of input signal or very low sound audibility.

■Muting

The volume is muted temporarily when pressing the button on the remote control. Press again to restore the volume.

■Function

When the FUNCTION button is pressed, the current function will change to different mode. Press the FUNCTION button repeatedly to select desired function.

CD USB

FM ST

AUDIO IN FM MONO

Note:

The backup function will protect the memorized function mode for a few hours should there be a power failure or the AC power lead becomes disconnected.

Setting the clock (Remote control only)

In this example, the clock is set for the 24-hour (00:00) display.

1Press the ON/STAND-BY button to turn to stand-by mode.

2Press and hold the (TIMER)/CLOCK button until “00:00” appear.

3Within 10 seconds, press the or button to adjust the hour and then press the MEMORY button.

Press the or button once to advance the time by 1 hour. Hold it down to advance continuously.

4Press the or button to adjust the minutes and

then press the MEMORY button. Press the or button once to advance the time by 1 minute. Hold it down to advance continuously.

To confirm the time display:

[When the unit is in the stand-by mode]

Press the (TIMER)/CLOCK button. The time display will appear for about 5 seconds.

[When the power is on]

Press the (TIMER)/CLOCK button. The time display will appear for about 5 seconds.

Note:

The “00:00” will appear when the AC power supply is restored after a power failure or unplugging the unit. Readjust the clock as follows.

To readjust the clock:

Perform “Setting the clock” from step 1.

EN

E-6

2012/ October/	12_XL-UR14H_OM_EN.fm
17