Turning the Projector On/Off
Connecting the Power Cord
Supplied | Power cord | |
accessory | ||
|
Plug the supplied power cord into the AC socket on the rear of the projector.
AC socket
Turning the Projector on
Note that the connections to external equip- ment and power outlet should be done be- fore performing the operations written be- low. (See pages 23 to 28.)
Remove the lens cap and press SSTANDBY/ON on the projector or bON on the remote control.
Note
•About the Lamp Indicator
The lamp indicator illuminates to indicate the status of the lamp.
Green: The lamp is on.
Blinking in green: The lamp is warming up
or shutting down.
Red:The lamp is shut down abnormally or the lamp should be replaced.
•When switching on the projector, a slight flick- ering of the image may be experienced within the first minute after the lamp has been illumi- nated. This is normal operation as the lamp’s control circuitry is stabilising the lamp output characteristics. It should not be regarded as faulty operation.
•If the projector is put into standby mode and immediately turned on again, the lamp may take some time to start projection.
Info
•English is the factory default language. If you want to change the
Lamp indicator
Power indicator
STANDBY/ON button
ON button
28
