13
Setup & Connections
Power Supply

Connecting the Power Cord

Plug the supplied power cord into the AC socket on the back of the projector.
Connections
Power cord
CAUTION
• Make sure the power cord is firmly connected into the AC socket.
• The configuration of wall outlets differs from country to country. Use the power cord that corresponds to the wall outlet in your country.
• The projector will enter the stand-by mode after turning the power off and then re-plugging the power cord into the AC socket. However,
if you turned off the power by disconnecting the power cord or because of a power failure, the projector will automatically turn on without
pressing the POWER ON button.
1Connect one end of the S-video cable (commercially
available) to the INPUT 3 S-VIDEO terminal, or one end
of the video cable to the INPUT 4 VIDEO terminal on
the projector.
2Connect the other end of the S-video cable or the video
cable to the S-video output or Video output terminal of
the video source.
The S-video input terminal uses a video signal system where
the picture is separated into a colour and luminance signal
to realise a higher-quality image.
• For higher quality video, you may use the S-video input terminal on the
projector. S-video cable is commercially available.
• If your video equipment does not have an S-video output terminal, use
the composite video output terminal.

Connecting a video source (VCR, laser disc player, DVD player or DTV decoder) using the INPUT 3

S-VIDEO and INPUT 4 VIDEO terminals

You can connect your projector to a VCR, laser disc player, DVD player, DTV* decoder and other video equipment.
* DTV is the umbrella term used to describe the new digital television system in the United States.
CAUTION
• Make sure to turn both the projector and the video equipment off, before connecting.
• As this projector is not equipped with audio input terminals, commercially available audio equipment or your own equipment (such as
speakers or amplifiers) should be used.
Connecting to Video Equipment