17
Setup & Connections
Power ON/OFF

Press POWER ON.

•The flashing blue LAMP REPLACEMENT indicator
shows that the lamp is warming up. Wait until the
indicator stops flashing before operating the projector.
•If the power is turned off and then immediately turned
on again, it may take a short while before the lamp
turns on.
•After the projector is unpacked and turned on for the first
time, a slight odour may be emitted from the exhaust
ventilative hole. This odour will soon disappear with use.
When the power is on, the LAMP REPLACEMENT
indicator lights, indicating the status of the lamp.
Blue: Lamp is ready.
Flashing blue: Warming up.
Red: Change the lamp.

Press POWER OFF.

Press POWER OFF again while the message is
displayed.
•If you accidentally pressed POWER OFF and do not want
to turn off the power, wait until the message disappears.
•When POWER OFF is pressed twice, the POWER indicator
will light up red and the cooling fan will run for about 90
seconds. The projector will then enter standby mode.
•Wait until the cooling fan stops running before disconnecting
the power cord.
•The power can be turned on again by pressing POWER
ON. When the power is turned on, the POWER indicator
and the LAMP REPLACEMENT indicators light blue.
TEMP. LAMP POWER
POWER
buttons
Projector
Remote control
Maintenance indicator
Zooming and Focusing
The picture can be zoomed in or out, and focused by the Zoom knob and the Focus ring.
1Slide the Zoom knob. The image can be
adjusted to the desired size within the zoom
range.
2Rotate the Focus ring until the image on the
screen becomes clear.
1
2