Using
the
Kensington
Lock
Rear View | This projector has a Kensington Security Standard |
connector for use with a Kensington MicroSaver Security | |
| System. Refer to the information that came with the |
| system for instructions on how to use it to secure the |
Kensington Security | projector. |
Standard connector |
|
Troubleshooting
Problem | Check |
No picture appears. | • Projector power cord is not plugged into the wall outlet. |
| • Selected input is wrong. (See page 24.) |
| • Cables incorrectly connected to back panel of the projector. (See pages |
| • “Contrast” and “Bright” adjustments are set to minimum position. (See page 43.) |
|
|
Color is faded or poor. | • Picture adjustments are not correct. (See page 43.) |
|
|
Picture is blurred. | • Adjust the focus. (See page 16.) |
| • Projection distance is too long or too short to allow for proper focus. (See pages 21 and 22.) |
|
|
No OSD appears. | • OSD Display is set to “OFF”, preventing to display some or all |
| page 36.) |
|
|
An unusual sound is occasion- | • If the picture is normal, the sound is due to cabinet shrinkage caused by temperature |
ally heard from the cabinet. | changes. This will not affect operation or performance of the projector. |
|
|
Maintenance indicator | • Refer to “Lamp/Maintenance Indicators” on page 44. |
illuminates. |
|
|
|
Picture noise appears. | • Adjust the “Phase” setting. (See page 33.) |
|
|
Image is green on INPUT 2 | • Change the input signal type. (See page 36.) |
Component. |
|
Image is pink (no green) on |
|
INPUT 2 RGB. |
|
|
|
For
SHARP Assistance
(U.S.A.
only)
If you encounter any problems during setup or operation of this projector, first refer to the “Troubleshooting” section on this page. If this operation manual does not answer your question, please call toll free
Our World Wide Web address is http://www.sharpusa.com/ .
Troubleshooting | Maintenance& | ||
|
|
|
|
|
|
|
|
|
|
|
|