Important

Information

 

 

 

 

 

 

 

 

 

 

 

 

IMPORTANT SAFEGUARDS

Temperature Monitor Function

If the projector starts to overheat due to setup problems “TEMP” and “” will blink in the lower-left corner of the picture. If the temperature continues to rise, the lamp will turn off, the TEMPERATURE WARNING indicator on the projector will blink, and after a 90-second cooling-off period the power will shut off. Refer to “Lamp/Maintenance Indicators” on page 44 for details.

•The cooling fan regulates the internal temperature, and its performance is automatically controlled. The sound of the fan may change during projector operation due to changes in the fan speed.

Lamp Monitor Function

When the projector is turned on after the lamp has been used for 2,400 hours, “LAMP” and “” will blink in the lower-left corner of the picture to advise you to replace the lamp. See page 46 for lamp replacement. If the lamp has been used for 2,500 hours, the projector power will automatically turn off and the projector will enter standby mode. Refer to “Lamp/Maintenance Indicators” on page 44 for details.

Using the Terminal Cover

When the projector is used on a desktop, high mounted or ceiling mounted, attach the terminal cover (supplied) to hide the connecting cables.

Attaching the Terminal Cover

1 Align with the tabs on the projector and then press the terminal cover in the direction of the arrow.

2 Tighten the two screws on the bottom of the projector.

1

2Tighten the screws

Removing the Terminal Cover

1 Loosen the two screws on the bottom of the projector.

2 Raise the terminal cover and pull it out in the direction of the arrow.

2

1Loosen the screws

E-5