Sherwood AX-5103 Read This Before Operating Your Unit, For U.S.A And Canada, For Other Countries

AX5103(G)2007.8.174:43PM페이지 2

READ THIS BEFORE OPERATING YOUR UNIT

FOR U.S.A AND CANADA	120 V	FOR OTHER COUNTRIES	110 V/ 220 V
FOR YOUR SAFETY		FOR YOUR SAFETY

ENGLISH

Units shipped to the U.S.A and Canada are designed for operation on 120 Volts AC only.

Observe all safety precaution for use of a polarized AC plug. However, some products may be supplied with a non polarized plug.

CAUTION : To prevent electric shock, match wide blade of plug to wide slot, insert fully.

FOR EUROPE AND AUSTRALIA 230 V/240 V

FOR YOUR SAFETY

Units shipped to Australia are designed for operation on 240 V AC only.

To ensure safe operation, the three-pin plug supplied must be inserted only into a standard three-pin power point which is effectively earthed through the normal household wiring. Extension cords used with the equipment must be three-core and be correctly wired to provide connection to earth.

Improper extension cords are a major cause of fatalities. The fact that the equipment operates satisfactorily does not imply that the power point is earthed and that the installation is completely safe.

For your safety, if in any doubt about the effective earthing of the power point, consult a qualified electrician.

PAN-EUROPEAN UNIFIED VOLTAGE

All units are suitable for use on supplies 230-240 V AC.

Units shipped to countries other than the above countries are equipped with an AC voltage selector switch on the rear panel. Refer to the following paragraph for the proper setting of this switch.

AC VOLTAGE SELECTION

This unit operates on 110/220 V AC. The AC voltage selector switch on the rear panel is set to the voltage that prevails in the area to which the unit is shipped.

Before connecting the power cord to your AC outlet, make sure that the setting position of this switch matches your line voltage. If not, it must be set to your voltage in accordance with the following direction.

AC voltage selector switch

AC 220 V AC 110 V

Move switch lever to match your line voltage with a small screwdriver or other pointed tool.

3