Sherwood R-525 Other Possibilities, Entering Video Labels, Subwoofer Level Control

SLEEP

The sleep mode allows the system to continue to operate for a specified period of time before automatically shutting off.

Press the SLEEP button.

–The display shows the indication SLEEP 10.

–This means that the system will be switched to standby after 10 minutes.

Select the required sleep time by pressing SLEEP : 10, 20, 30, 60 or 90 minutes.

Notes:

–During an active sleep timer period, you can reset the SLEEP time again by pressing the SLEEP button.

–A sleep timer period will be cancelled when you switch your system to standby (using the POWER button on your remote control).

ENTERING VIDEO LABELS

–It can be operated only on video functions such as VCR1, VCR2, and LDP.

Select the desired video input to enter its label. Press the VIDEO LABELS button for more than 2 seconds.

Rotate the INPUT SELECTOR/INDEX to select the first character of the video label.

–Characters which can be selected are total 46 as follows; 26 Capital Letters : A B C D E F G H I J K L M N O P Q R

S T U V W X Y Z

10 Arabic Numerals : 1 2 3 4 5 6 7 8 9 0

10 Special Marks : ' < > + , – / \ . Press the MEMORY/ENTER button to store it.

–If you press the button for more than 2 seconds on the character, a dot will appear by the character.

Repeat the same steps as described above to store the rest of up to 8 characters.

Note : This procedure must be done in a timely fashion.

CINEMA BASS

You can turn on CINEMA BASS to enjoy impressive bass sound by pressing it.

Press it again to cancel.

OTHER POSSIBILITIES

SUBWOOFER LEVEL CONTROL

Use the SUBWOOFER LEVEL buttons on the remote control to adjust the subwoofer level.

– The level will be indicated on the display : MIN, -21,. , - 2, -1, 0, 1, 2, . , +8, MAX.

AUDIO RECORDING

Recording with TAPE 1

Select the desired input as recording source.

Start recording on the TAPE 1.

Start play on the desired input.

Recording with TAPE 2 MONITOR

Select the desired input as recording source.

Set the TAPE MONITOR button to on.

Start recording on the TAPE 2 MONITOR.

Start play on the desired input.

–When the TAPE 1 is selected as recording source, dubbing will start from TAPE 1 to TAPE 2 MONITOR.

–It is not impossible to dub from TAPE 2 MONITOR to TAPE 1.

–For tape 2 monitor function, refer to amplifier chapter titled "TAPE 2 MONITOR function".

RECORDING WITH VCR 1

Dubbing from LDP(VCR 2) to VCR 1

Select LDP(VCR 2) as the input being enjoyed.

Select LDP(VCR 2) as recording source with the VCR 1 RECORD button.

–Each time this button is pressed, the recording source changes as follows;

LDP VCR2 SOURCE

Start recording on the VCR 1.

Start play on the LDP(VCR 2).

–The audio and video signals from LDP(VCR 2) will be dubbed onto the tape in VCR 1 and you can enjoy LDP(VCR 2) on TV monitor and from speakers.

Listening to other audio input during dubbing Example)Listening to CD during dubbing from LDP to VCR 1

Select CD as the input being enjoyed.

Select LDP as recording source with the VCR 1 RECORD button.

Start recording on the VCR 1. Start play on the LDP.

Start play on the CDP.

–The audio and video signals from LDP will be dubbed onto the tape in VCR 1 and you can listen to CD.

ENGLISH

11