Sherwood R-904 manual SETTING THE SYSTEm, When selecting the AmP ASSIGN, When selecting the TONE

R-904(G)_ENG_091014:R-904(G) 2009-11-11 오후 12:05 페이지 35

SETTING THE SYSTEm

AMP : BACK / R2
TONE : OFF / ON	TRE : 0 / -10 ~ +10
	BASS : 0 / -10 ~ +10

•AMP (AMP ASSIGN) : To assign the surround back channels' power amplifier correctly depending on how to use the speakers.

•TONE : To adjust the tone (bass and treble) as desired.

1. Press the CURSOR UP/DOWN buttons to select the desired item.

2. Press the CURSOR LEFT/RIGHT buttons to set the selected item as desired.

■When selecting the AmP ASSIGN

•The surround back channels' power amplifier can drive the surround back speakers or the ROOM 2 speakers. Depending on how to use the speakers, you should assign the power amplifier correctly. (For details, refer to “CONNECTING SPEAKERS” on page 7 and “CONNECTING ROOM2 SPEAKERS” on page 8.)

BACK (SURROUND BACK) : To drive the surround back speakers when connecting the SURROUND BACK/ROOM2 channels

↕ to them.

R2 (ROOM2) : To drive the ROOM2 speakers when connecting the SURROUND BACK/ROOM2 channels to them.

■When selecting the TONE

OFF : To listen to a program source without the tone effect. (“DIR” lights up.)

↕

ON : To adjust the tone for your taste. (“DIR” goes off.)

◆When the TONE CONTROL is set to ON to adjust the tone (bass and treble)

①. Press the ENTER button to enter the tone adjustment mode.

• Then “TRE ~” will be displayed.

②. Press the CURSOR UP/DOWN buttons to select the desired tone mode.

③. Press the CURSOR LEFT/RIGHT buttons to adjust the selected tone as desired.

•The tone level can be adjusted within the range of -10 ~ +10 dB.

•In general, we recommend the bass and treble to be adjusted to 0 dB (flat level).

•Extreme settings at high volume may damage your speakers.

•To complete tone adjustment, repeat the above steps ② and ③.

ENGLISH

35