6. CONNECTING SPEAkERS
• Be sure to connect speakers firmly and correctly according to the channel(left and right) and the polarity (+ and
• When using only one surround back speaker, you should connect it to SURROUND BACK/ ROOM2 LEFT channel.
•Because this receiver cannot drive the surround back speakers and the ROOM2 speakers
simultaneously, you should assign their power amplifier correctly depending on how to use them. (For details, refer to "CONNECTING ROOM2 SPEAKERS" on page 8 and "When selecting the AMP ASSIGN" on page 35.)
• For installing the speakers, refer to "Speaker placement" on page 8.
• After installing the speakers, first adjust the speaker settings according to your environment and speaker layout. (For details, refer to "SETTING THE ROOM EQ" on page 36.)
Caution :
• Be sure to use the speakers with the impedance of 6 ohms or above.
•Do not let the bare speaker wires touch each other or any metal part of this unit. This could damage this unit and/or the speakers.
•Never touch the speaker terminals while the AC input cord is connected to the wall AC outlet. Doing so could result in electric shocks.
■Connecting speaker wire |
|
|
|
|
|
|
| ||
|
|
|
|
| |||||
1. Strip away approx. 10 mm | 2. Loosen by turning the | 3. Insert the bare part of the | 4. Tighten by turning it | ||||||
(3/8 inch) of wire insulation, | speaker terminal counter- | wire. | clockwise. | ||||||
then twist the wire ends | clockwise. |
|
|
|
|
|
| ||
|
|
|
|
|
| ||||
|
|
|
|
|
| ||||
tight. |
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
ENGLISH
7
