Sherwood RD-7106 manual Checking the speaker setting, Adjusting each channel level, English

4	Enter the subwoofer mode while it is	5	Select the desired subwoofer setting.
	displayed.		ADJUST
	SPEAKER
	MODE
		Each time this button is pressed, the subwoofer
		setting changes and is displayed for 8 seconds as
		follows;
If the speaker setting display disappears, start from		SUB W(oofer) -- Y(es): When using a powered
			subwoofer.
the above step 2 again.
		SUB W(oofer) -- N(o): When not using a powered
			subwoofer.
		If the front speakers are set to “S”, the subwoofer is
		automatically set to “Y”.
6	To memorize the speaker setting, press the	Checking the speaker setting
	MEMO/ENTER button while your choice
	is displayed.
			SPEAKER
	MEMO/ENTER		MODE

Your requested speaker settings are entered into		Each time this button is pressed briefly, the current
memory.
		front-center-rear speaker or subwoofer setting is
If the subwoofer display disappears before the
		displayed.
MEMO/ENTER button is pressed, you must start
again from step 2, above.
Adjusting each channel level		8	Adjust the level of the selected channel
			as desired.
Select the desired channel.
7
CHANNEL			ADJUST
SELECTOR
or	CH SEL.		or	CH LEVEL

Each time this button is pressed, the corresponding				If the channel display disappears, start from the
				above step 7 again.
channel is selected and displayed for 3 seconds as
follows;
	Front Left	Center	Front Right
	SubWoofer	Rear Left	Rear Right	9	Repeat the above steps 7 and 8 to adjust
When it is in the normal stereo mode or the speaker					other channel levels.
setting is “N”, center, rear or subwoofer channel
will not be selected.

ENGLISH

17