Sherwood RD-7106 manual Using the OSD, Current Status Display, Menu Screen, English

Using the OSD

This unit incorporates an OSD(On-screen display) function to provide information about basic operation of this unit and to simplify the set-up procedures.

The OSD function uses a monitor TV connected to this unit as a display and has two kinds of display modes; Current Status Display and Menu Screen.

Notes:

Any on-screen display shown on the monitor TV will not be recorded onto VIDEO 1.

In some countries, this unit allows you to select either NTSC or PAL color system as your video format.

If it is different from your video components and video software, etc., while in the standby mode, press the STANDBY button while keeping the CHECK button pressed on the front panel, then the video format will change to the NTSC or the PAL color system.

However, in some countries, only the NTSC system is available.

CURRENT STATUS DISPLAY

This mode shows the status corresponding to each operation.

The on-screen display will automatically disappear in 5 seconds.

For example, there are 2 status displays as follows.

When selecting the desired input source.			When selecting the TEST TONE mode.
				((		))
	VIDEO 1 (OPTICAL 1)				FL		C		FR
							SW
					RL			RR
				FL -----------------				------------------- 0
Input source		Signal input	Channel level or overall volume display

When adjusting each channel level or overall volume, the volume level display will be shown.

The test tone display will be shown until the test tone mode is canceled.

MENU SCREEN

This function simplifies the set-up procedures for items such as the speaker mode, function select, surround mode, delay time and channel level trim.

The menu screen operation is performed easily with the CURSOR control( , , , ), ON SCREEN DISPLAY and ENTER buttons.

Turn the menu screen on.

1		MAIN MENU
	SPEAKER MODE
	FUNCTION SELECT
	SURROUND MODE
OSD	DELAY TIME
	CH LEVEL TRIM
	up/down : MOVE
	OSD : END	ENTER : SELECT
		Main menu display
	In the button of the display, “up” stands for the CURSOR
The main menu will be shown.	UP( ) button. “down” for the CURSOR DOWN( ),
To turn the menu screen off, press this button,	“OSD” for the ON SCREEN DISPLAY and “ENTER” for
again.	the ENTER button.

ENGLISH

25