Shindaiwa 82014, T2510X manual Assembly and Adjustments, Handle, Adjust Throttle Lever Free Play

Assembly and Adjustments

Handle

Barrier

Handle Bar

Outer

Tube

	4 Socket-head Cap
Figure 5	screws

Handle

Handle Positioning Label

	Outer Tube
	Barrier
4 Socket-head Cap	Bar
screws	Figure 5A

Handle

1.The handle is attached to the outer tube at the factory and positioned vertically. See Figure 5.

2.Loosen the 4 socket-head cap screws on the handle and rotate the handle 90 degrees. See Figure 5A.

3.Position the handle forward of the Handle Positioning Label at the best position for operator comfort (usually about 10 inches ahead of the throttle housing).

4.Secure the handle by alternately tightening the four socket-head cap screws in a diagonal or “crisscross” fashion.

Assembly and Adjustments

Adjust Throttle Lever Free Play

The throttle lever free play should be approximately 3/16-1/4 inch (4-6 mm). See Figure 6. Make sure that the throttle lever operates smoothly without binding.

If it becomes necessary to adjust the lever free play, follow the procedures and illustrations that follow.

	251043	3/16-1/4 inch (4-6 mm)
Figure 6		Throttle Free Play

Figure 7

1.Loosen the air cleaner cover knob and remove the air cleaner cover.

See Figure 7.

2.Loosen the lock nut on the cable adjuster. See Figure 8.

3.Turn the cable adjuster in or out as required to obtain proper free play 3/16-1/4 inch (4-6 mm). See Figure 8.

4.Tighten the locknut.

Cable
Adjuster
Figure 8	Lock Nut

5. Reinstall the air cleaner cover.