Assembly
Blade T2510X
Mount the Saw Blade.
Turn the T2510X upside down so the gear case output shaft is facing UP and remove the shaft bolt, bolt guard and holder B from the gear case shaft.
1.Align the hole in blade holder A with the matching hole in the gear case flange and then temporarily lock the output shaft by inserting a hex wrench through both holes. See Figure 12.
2.Slide the safety clip
3.Fit the blade over the safety clip and then center it over the flange on holder A. See Figure 14.
CAUTION!
Install the blade so its printed surface is visible to the operator when the brushcutter is in the normal operating position.
WARNING!
Shaft Bolt
Bolt Guard
Holder B
Gear Shaft
Safety Clip
Holder A
Hex Wrench
Figure 12
Slide the safety clip
Output
Shaft
Safety
Clip
Figure 13
Slip the Saw Blade | Slide the Safety Clip | |
Back | ||
In Place | ||
|
Figure 14
The blade must fit flat against the holder flange. The blade mounting hole must be centered over the raised boss on blade holder A.
NOTE:
When installing certain blades, it may be necessary to temporarily remove the safety clip.
4.Lock the blade in place by centering the safety clip on the output shaft. See Figure 14.
WARNING!
Never operate the T2510X without the safety clip in place!
IMPORTANT!
The machined recess in holder B must completely surround the safety clip, and both holders must be flat against the surface of the blade.
5.Install blade holder B on the output shaft. See Figure 15. The recess in the holder must completely cover the safety clip, and must fit tightly against the blade.
Output
Blade Shaft
Blade Holder B | Hex Wrench |
|
| Tighten the assembly | |
| (blade not shown for clarity) | |
Figure 15 |
| |
6. Install the bolt guard and then the blade |
| |
The T2510X should now be | ||
retaining bolt. Using the combination | ||
completely assembled and | ||
spark plug wrench/screwdriver, tighten | ||
the bolt firmly in a | ready for use with a blade. | |
direction. |
| |
| ||
7. Remove the hex wrench. |
|
