Shindaiwa 81188 manual Product Description, Specifications C3410, Prior to Assembly

Product Description

C3410 BRUSHCUTTER	Ignition	Spark Plug
	Switch	Throttle
		Interlock
		Muffler

Throttle

Trigger

Hanger

Fuel

Tank

Outer Tube

Gear Case

Cutting

Attachment Shield

Brushcutter Blade

Figure 4

Using the accompanying illustrations as

Handle Bar a guide, familiarize yourself with this unit and its various components. See Figure 4. Understanding your unit helps ensure top performance, long service life, and safer operation.

WARNING!

Do not make unauthorized modifica- tions or alterations to any of these units or their components.

Specifications C3410

C3410 dry weight	...................................................14.1 lb./6.4 kg	Air cleaner type	Non-reversible heavy-duty
(less attachments)
Engine model	SF3410E		filter element
		Starting method	Recoil
Engine type	with Power Boost Chamber
		Stopping method	Slide switch
Bore x stroke	......................1.5 x 1.2 in./38 x30 mm
		Transmission type	Automatic, centrifugal clutch
Displacement	2.1 cu. in./ 34 cc
			w/bevel gear
Maximum power	1.4 HP/1.0 kW	EPA Emission
	@ 8,000 RPM (min-1)	Compliance Period**	Category A

Fuel/oil ratio	50:1 with ISO-L-EGD or JASO FC
	class 2-cycle mixing oil*
Carburetor type	Walbro WYL, diaphragm-type
Fuel tank capacity	23.7 oz./700 ml
Ignition	One-piece electronic,
	program-controlled
Spark plug	NGK CMR5H

**The EPA emission compliance referred to on the emission compliance label located on the engine, indicates the number of operating hours for which the engine has been shown to meet Federal emission requirements. Category C = 50 hours (Moderate), B = 125 hours (Intermediate) and A = 300 hours (Extended).

*meets or exceeds these specifications and is recommended for all Shindaiwa products.

Specifications are subject to change without notice.

This unit comes fully assembled with the exception of the handlebar cutting attach- ment shield and cutting attachment.

Prior to Assembly

Before assembling, make sure you have all the components required for a complete unit and inspect unit and components for any damage.

Engine/Outer tube assembly

Handlebar and Throttle assembly

Cutting attachment

Kit containing cutting attachment shield mounting bracket and hardware, this owner’s/operator’s manual and tool kit for routine maintenance. Tool kits vary by model and may include a hex wrench set, a spark plug/screwdriver combination wrench, and a spanner.

IMPORTANT!

The terms “left”, “left-hand”, and “LH”; “right”, “right-hand”, and “RH”; “front” and “rear” refer to directions as viewed by the operator during normal operation.

5